Extron electronic sDVI DL 201 TX/RX دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Setup Guide — DVI DL 201 Tx/Rx
®
The Extron DVI DL 201 Tx and DVI DL 201 Rx are dual
link DVI transmitter (Tx) or receiver (Rx) units. Using
three CAT 5/5e/6/7 twisted pair cables, DVI-D signals
can be extended up to 100 feet (30 m) at resolutions up to
2560x1600 @ 60 Hz. They can be purchased as a pair or as
individual units.
These instructions provide a quick setup guide for experienced installers. Installation
W
and service must be performed by authorized personnel only.
The DVI

ملخص المحتوى في الصفحة رقم 2

Setup Guide — DVI DL 201 Tx/Rx (cont’d) EDID d. Press and release the EDID “Store” button (see the figure at right). The rear panel LED turns amber while the EDID information is read and STORE stored from the local monitor. Afterwards, the LED turns green. e. Power off and disconnect the display from the transmitter. f. Connect the transmitter to the receiver. g. Connect a source device to the transmitter. h. Connect a display device to the receiver and, if required, a local monitor to the