ملخص المحتوى في الصفحة رقم 1
operation manual
VX-860
VX-850
Miller & Kreisel Sound, Inc.
9351 Deering Avenue
Chatsworth, CA 91311-5858 USA
(818) 701-7010 fax (818) 701-0369
www.mksound.com
©2004 Miller & Kreisel Sound, Inc.
powered subwoofer
ملخص المحتوى في الصفحة رقم 2
POWERED SUBWOOFER TABLE OF CONTENTS 1. SAFETY INSTRUCTIONS.......................................................................................3 2. INTRODUCTION................................................................................................4 3. VOLTAGE SELECTOR & POWER CORD.....................................................................4 4. WHERE TO LOCATE YOUR SUBWOOFER.................................................................4 5. SUBWOOFER HOOK-UP.............
ملخص المحتوى في الصفحة رقم 3
POWERED SUBWOOFER The exclamation point within an The lightning flash with arrowhead, CAUTION: equilateral triangle is intended to within an equilateral triangle, is TO PREVENT THE RISK OF ELECTRIC SHOCK, alert the user of the presence of intended to alert the user of the DO NOT REMOVE COVER (OR BACK). NO USER- important operating and mainte- presence of uninsulated “dangerous SERVICEABLE PARTS INSIDE. REFER SERVIC- nance (servicing) instructions in voltage” within the product's enclo- the liter
ملخص المحتوى في الصفحة رقم 4
POWERED SUBWOOFER 2. INTRODUCTION Congratulations! You have just made perhaps the most exciting and dramatic addition that you could make to your audio or multichannel audio/video system. The new dimension of deep and powerful bass provided by your M&K VX-series powered subwoofer will thrill and excite you. We encourage you to read this owner's manual, as there is a great deal of information provided here to help you get the best possible performance. This manual gives you basic hook-up i
ملخص المحتوى في الصفحة رقم 5
POWERED SUBWOOFER Ultimately, the amount and quality of bass you get in your room are dependent on the room itself. Low frequency bass sounds are affected most by the size of the room and the method of construction used to build it. All rooms are different when it comes to reproducing bass, and in any given room, bass quantity and quality changes when the sub- woofer is moved from one location to another. A simple rule to remember is that you get more bass when you move the subwoofer towards a
ملخص المحتوى في الصفحة رقم 6
POWERED SUBWOOFER FIGURE 1 - CONNECTING TO A COMPONENT’S SUBWOOFER OUTPUT SUB / MONO OUT SUBWOOFER REF SURROUND PROCESSOR OR RECEIVER This will give you better bass quality than using the speaker inputs, because it bypasses your amp or receiver's amplifier stage. To connect the subwoofer in this way, simply run one or a pair of shielded RCA - RCA interconnect cables from the output jacks on your component to the "LINE LEVEL" jacks on the Subwoofer's backplate. If you run one cable, connect it
ملخص المحتوى في الصفحة رقم 7
POWERED SUBWOOFER If you don't have a subwoofer output available, check to see if you have preamp outputs on your preamp, amp, or processor to be able to use these inputs. If you have only one set of preamp outputs, use a Y-connector to feed both the amplifier and the subwoofer. See Figure 2. Use a Y-connector to connect the signal to both the LEFT and RIGHT inputs of the subwoofer. These inputs are summed to mono in the amplifier input stage of the subwoofer. USING SPEAKER WIRE CONNECTIONS
ملخص المحتوى في الصفحة رقم 8
+ POWERED SUBWOOFER 2. You can also connect your satellite speakers to the subwoofer. If you choose to do this, connect the amplifier to the "From Amplifier" terminals on the back of the subwoofer and connect the satellite speakers to the "To Speakers" terminals on the back of the subwoofer. For each channel, make sure that the Positive (+) terminal on the amplifier is connected to the Positive (+) "From Amplifier" terminal (and the Negative (-) terminals are connected), and that the Positive
ملخص المحتوى في الصفحة رقم 9
POWERED SUBWOOFER where the subwoofer sounds in balance with the satellite speakers. If the system is not working properly, unplug the subwoofer and check all of your connections. Call your dealer or the factory if you cannot solve any problem. 6. USE OF THE “PHASE” CONTROL Your subwoofer has a phase control that allows for continuous adjustment between 0˚and 180˚ degrees. This con- trol let you fine tune the transition between the subwoofer and your other speakers. To optimize the sound
ملخص المحتوى في الصفحة رقم 10
POWERED SUBWOOFER 9. USING MULTIPLE SUBWOOFERS Using two (or more) subwoofers in your system gives you the ultimate in bass performance. You'll hear improved impact and definition, as well as greater output and dynamic range. If multiple subwoofers are used, place them in the same location. Stacking is best, but you can also put them side by side. Alternately, you can put multiple subwoofers in different locations. This is appropriate when you have limited choices in locating the subwoo
ملخص المحتوى في الصفحة رقم 11
POWERED SUBWOOFER 5. If the red LED is lit, try this test: Turn the "BASS LEVEL" control to "MIN". Plug a standard RCA cable into the "FROM PREAMP" jacks. Lightly touch the plug at the free end of the cable, while slowly turning the "BASS LEVEL" control clockwise. If you hear noise from the subwoofer when you touch the cable, the subwoofer is functioning. Look elsewhere in your system for the problem. If you hear no noise, contact your dealer or M&K. 6. Make sure that the input cables are
ملخص المحتوى في الصفحة رقم 12
POWERED SUBWOOFER IF YOU NEED TO REPLACE THE EXTERNAL FUSE: Disconnect supply cord before changing fuse. Replace fuse only with same type. Remove the fuse cap and inspect the fuse. Look carefully at the fuse. If the wire filament inside the glass is bro- ken, replace the fuse ONLY with one of the identical size and value. Using a fuse of a larger value will void your war- ranty AND MAY CREATE A FIRE HAZARD. Plug the subwoofer back in. If it does not work, unplug it immediately, and contact
ملخص المحتوى في الصفحة رقم 13
POWERED SUBWOOFER B. Locate the subwoofer. 1. The best place for the subwoofer is the corner with the best structural strength. If the corners are roughly equal in construction, use the corner nearest the listening position. If the listening position is in the front half of the room, place the subwoofer in a front corner. If it is in the back of the room, place the subwoofer in a back corner. If possible, avoid corners near doorways or openings. 2. If you are willing to experiment, another
ملخص المحتوى في الصفحة رقم 14
POWERED SUBWOOFER G. If you have a Pro-Logic only processor/receiver, follow these instructions. SPECIAL NOTE: Always check the processor/receiver/receiver’s owner’s manual. Different manufacturers use different descriptions for the same function, and sometimes the same description for different functions! Your component may use terminology different from that used below. 1. If the component has high-pass filters for the Left, Center, and Right channels (usually only THX components have these
ملخص المحتوى في الصفحة رقم 15
POWERED SUBWOOFER 14. SPECIFICATIONS VX-860 ENCLOSURE TYPE: Sealed Box WOOFER: Single 12" Driver POWER RATING: 250 watts RMS FREQUENCY RESPONSE: 20Hz - 200Hz ± 3dB DIMENSIONS (HxWxD): 0” x 0” x 0” WEIGHT: lbs./ kg. VX-850 ENCLOSURE TYPE: Sealed Box WOOFER: Single 12" Driver POWER RATING: 250 watts RMS FREQUENCY RESPONSE: 20Hz - 200Hz ± 3dB DIMENSIONS (HxWxD): 0” x 0” x 0” WEIGHT: lbs./ kg. VX-860/VX-850 subwoofer manual 10/26/04 pt/qrk PN # 70054 15
