ملخص المحتوى في الصفحة رقم 1
PRIMERGY TX150 S4
System configurator and order-information guide
December 2005
Contents
Instructions
Configuration diagram
Configurator
0 System software
I Basic unit
II Processor
III Memory
IV Graphics
V Accessible drives
VI Hard disk drives
VII SCSI Controller
VIII Disk array
IX Communication/Network
X System management options
XI Miscellaneous
XII Country specific options
Change report
PRIMERGY Server
ملخص المحتوى في الصفحة رقم 2
System configurator and order-information guide PRIMERGY TX150 S4 Status 25.11.2005 Instructions This document contains basic product and configuration information that will enable you to configure your system via PC-/ System-Architect. Only these tools will ensure a fast and proper configuration of your PRIMERGY server or your complete PRIMERGY Rack system. You can configure your individual PRIMERGY server in order to adjust your specific requirements. The System configurator is divi
ملخص المحتوى في الصفحة رقم 3
System configurator and order-information guide PRIMERGY TX150 S4 Status 25.11.2005 Configuration diagram PRIMERGY TX150 S4 System unit ( I ) SIDE VIEW FRONT VIEW 3 x 5.25" Standard Power Supply or PS (I) 5.25" x 1.6" 1. PSU 2. PSU Redundant power supply option 5.25" x 1.6" 5.25" x 1.6" CD / DVD drive Modul 1 Pentium 4 Modul 3 3.5"x1" Floppy disk (optional) Modul 2 Accessible drives ( V ) Modul 4 Processor ( II ) Memory ( III ) Extension slots SCSI Controller ( VII ) Disk arra
ملخص المحتوى في الصفحة رقم 4
System configurator and order-information guide Start PRIMERGY TX150 S4 PRIMERGY TX150 S4 Status 25.11.2005 SW Configurator IA32 with OEM-Software without OEM-Software for PRIMERGY Server for PRIMERGY Server Later use of OEM operating system VMware-Software software is not allowed, - VCMS VirtualCenter Management Server apart from few VMware - GSX Server and GSX Virtual Infrastructure Node add-ons - P2V Assistant Enterprise Edition For all SW products please refer to the correspond
ملخص المحتوى في الصفحة رقم 5
System configurator and order-information guide Start PRIMERGY TX150 S4 PRIMERGY TX150 S4 Status 25.11.2005 SW Configurator EM64T with OEM-Software without OEM-Software for PRIMERGY Server for PRIMERGY Server Later use of OEM operating system software is not allowed, apart from few VMware add-ons For all SW products please refer to the corresponding software configurator accessible via the Extranet under Configuration & Tools, -All configurations, -Software, URL see below. Microsof
ملخص المحتوى في الصفحة رقم 6
System configurator and order-information guide Start PRIMERGY TX150 S4 PRIMERGY TX150 S4 Status 25.11.2005 Section Basic unit I System unit consisting of: * Housing including standard power supply (no redundancy) * Sliding screen with lock (only for floorstand version) Systemboard with: * 7 PCI slots: 1x PCIe x 1 1x PCIe x 4 (x8 Slot) 1x PCI-X 66 long (3,3V) 1x PCI-X 66 (3,3V) ZCR Slot 1x long / 2x short 32Bit / 33MHz (5V) * 4 memory slots for up to 8GB (PC4200)
ملخص المحتوى في الصفحة رقم 7
System configurator and order-information guide A PRIMERGY TX150 S4 Status 25.11.2005 Floorstand version SCSI basic unit 19" Rack version SCSI basic unit (5 U) Pentium 4 processor, memory Pentium 4 processor, memory PD 820 2.8GHz/800MHz/2x1MB 512MB S26361-K999-V136 PD 820 2.8GHz/800MHz/2x1MB 512MB S26361-K999-V336 PD 820 2.8GHz/800MHz/2x1MB 1GB S26361-K999-V146 PD 820 2.8GHz/800MHz/2x1MB 1GB S26361-K999-V346 PD 820 2.8GHz/800MHz/2x1MB 2GB S26361-K999-V156 PD 820 2.8GHz/800MHz/2x1MB 2GB
ملخص المحتوى في الصفحة رقم 8
System configurator and order-information guide B1 B2 PRIMERGY TX150 S4 Status 25.11.2005 PRIMERGY Floorstand PRIMERGY Rack PRIMECENTER- Rack SNP:SY-F1647E301-P "rack-mounting ex factory" Installation ex works for one This service is to be ordered once server or subsystem per installable server/storage Hereby the rack will be delivered subsystem, in order to get the completely pre-mounted and server/storage subsystem all wired connections are tested mounted into the PRIMERGY racks. Wit
ملخص المحتوى في الصفحة رقم 9
System configurator and order-information guide C PRIMERGY TX150 S4 Status 25.11.2005 Section Processor II Section Memory III There are 2 memory banks with 2 DIMM slots each. Single channel memory configuration allow maximum flexibility: Additional memory can be configured as single memory modules. Dual channel memory configurations for maximum performance: For optimum performance memory has to be configured in pairs of memory modules with identical size. S26361-F3000-E513 S26361-F300
ملخص المحتوى في الصفحة رقم 10
System configurator and order-information guide D PRIMERGY TX150 S4 Status 25.11.2005 Section Accessible drives V There are 3x 5.25" bays for accessible drives: - 1x 5.25" bay is occupied by a DVD-/CD- respectively a CD-RW drive - 2 x 5.25" bays remaining, can be occupied by 2x accessible drives Setup TX150 S4 by ServerStart is supported with following configurations: no DVD, no CD: remote installation only ( PXE service & DHCP server required) built in CD/DVD: UNC Network share reac
ملخص المحتوى في الصفحة رقم 11
System configurator and order-information guide E PRIMERGY TX150 S4 Status 25.11.2005 S26361-F2814-E6 Backup drive and hard disk should run on separate channels 68-Pin Kit for accessible drives Cable with Terminator To connect acc. drives to If internal HDD's are connected at the RAID controller separate SCSI controller (not IME/ZCR), then for internal accessible drives max. 1x per system the cable S26361-F2814-E6 must be ordered additionally! Section Hard Disk Drives VI S26361-F3121-E
ملخص المحتوى في الصفحة رقم 12
System configurator and order-information guide F PRIMERGY TX150 S4 Status 25.11.2005 Section SCSI-Controller VII All internal cables and adapters are included within the basic units and components respectively Cabeling priorities: internal HDs are cabled according to following priorities. (Prio 1 - 3 ): 1.) For a configuration without any Disk Array Controller and without zero channel RAID the onboard U320 Controller is connected to the internal HDs. 2.) For a configurati
ملخص المحتوى في الصفحة رقم 13
System configurator and order-information guide G PRIMERGY TX150 S4 Status 25.11.2005 B. SCSI controller for internal backup drives S26361-F2399-E2 SCSI 160 Controller Adaptec SCSI Card 29160 1 channel: LVD + Fast/ Ultra (decoupl.) LVD connect. for HD, without cable Fast/Ultra connect. for acc. drives 64/66 PCI, min 180 mm int: Fast 50-pin or Ultra HD68 + LVD HD68; ext: HD68(LVD) SW: max. 1x per system S26361-F2814-E6 68-Pin Kit for accessible drives Cable with Terminator To connect a
ملخص المحتوى في الصفحة رقم 14
System configurator and order-information guide H PRIMERGY TX150 S4 Status 25.11.2005 continued on previous E. 2-Kanal Ultra 320 SCSI Controller für Disk Array page S26361-F3090-E256 2-channel RAID Controller U320 LSI 320-2x 256MB SDRAM ECC Cache default with TBBU 1x plug: internal 2x HD68; external: 2x VHDCI without cable 64/133 PCI-X controller, 180mm 3.3V and 5V tolerant signaling max. 1x per system The fitting connection cables can be found in the configurator of the external s
ملخص المحتوى في الصفحة رقم 15
System configurator and order-information guide I PRIMERGY TX150 S4 Status 25.11.2005 Section Communication / Network IX Gigabit Ethernet Contr. on-board The Intel LAN controllers 1000MT can be used Broadcom with the on-board controller in Teaming Mode ext: for RJ 45-connector SW: AFT, VLAN, Fast Channel S26361-F3053-E1 S26361-F3142-E1 Gigabit Ethernet Contr. 1000TX Gigabit Ethernet Contr. 1000TX Eth. Ctrl 1x1Gbit PCI-X Pro/1000MT Cu Eth. Ctrl 1x1Gbit PCI32 PRO/1000GT Cu Intel PRO/1000
ملخص المحتوى في الصفحة رقم 16
System configurator and order-information guide J PRIMERGY TX150 S4 Status 25.11.2005 Section System management options X S26361-F2425-E103 RSB S2 LP 3HU RemoteView Service Board S2 Low Profile Version with 3 U bracket for one standard PCI-slot incl. cables and RV SW max. 1x per system S26361-F2425-E305 RSB S2 LP external power supply RemoteView Service Board S2 low profile external power supply including power cable with Euro- and Euro socket connector Section Miscellaneous XI S26361-
ملخص المحتوى في الصفحة رقم 17
System configurator and order-information guide K PRIMERGY TX150 S4 Status 25.11.2005 Section Country specific / rack specific options XII A country specific power cord has to be ordered for all floorstand versions: - once per basic unit and an additional second cable - if an second hot plug, redundant power supply modul is ordered. PRIMERGY TX150 S4 Floorstand PRIMERGY TX150 S4 Rack Power cord for following countries: 1,8 m, grey Country specific power cords are not required for
ملخص المحتوى في الصفحة رقم 18
System configurator and order-information guide PRIMERGY TX150 S4 Status 25.11.2005 Cange Report Date Order number Changes 2005-11-23 S26361-F1809-E2 ISDN SO Controller PCI Eicon Diva Server BRI-2M 2.0 - now available 2005-03-31 First release Fujitsu Siemens Computers Enterprise Products - PRIMERGY Server 18 of 18
