ملخص المحتوى في الصفحة رقم 1
Dell™ PowerEdge™ C1100
Getting Started
With Your System
Guide de mise en route
Primeiros passos com o sistema
Procedimientos iniciales con el sistema
ملخص المحتوى في الصفحة رقم 2
ملخص المحتوى في الصفحة رقم 3
Dell™ PowerEdge™ C1100 Getting Started With Your System Regulatory Model CS24-TY
ملخص المحتوى في الصفحة رقم 4
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. ____________________ Information in this document is subject to change without notice. © 2010 Dell Inc. All rights reserved. Reproduction of these materials in any manner
ملخص المحتوى في الصفحة رقم 5
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking the System Unpack your system and identify each item. Installing the Tooled Rail Solution WARNING: Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the system by yourself. WARNING: The system is not fixed to the rack or mounted on the rails. To avoid personal injury or damage to the syst
ملخص المحتوى في الصفحة رقم 6
1 Install the sliding rails into the rack. 2 Align the inner rails with the sliding rails of the rack and push the system into the sliding rails until the locking latch clicks into place. 4 Getting Started With Your System
ملخص المحتوى في الصفحة رقم 7
3 Slide the system into the rack and tighten the thumbscrews to secure the ears of system to the front of the rack. Installing the Tool-less Rail Solution WARNING: Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the system by yourself. WARNING: The system is not fixed to the rack or mounted on the rails. To avoid personal injury or damage to the system, you must adequately support the system rack during installation and removal. CAU
ملخص المحتوى في الصفحة رقم 8
1 Align the end pieces of the rails on the vertical rack flanges to seat the pegs in the bottom hole of the first U and the top hole of the second U, and engage the back end of the rail until the latch locks in place. NOTE: The rails can be used in both square- and round-hole racks. 2 Repeat these steps to position and seat the front end piece on the vertical flange. 3 To remove the rails, pull on the latch release button on the end piece midpoint and unseat each rail. 6 Getting Started Wit
ملخص المحتوى في الصفحة رقم 9
4 Align the four keyhole slots on the chassis rails with the corresponding pins on the system and slide the chassis rails towards the back of the system until it locks into place. 5 Align and insert the ends of the chassis rails into the ends of the rails and push the system inward until the chassis rails lock into place. Getting Started With Your System 7
ملخص المحتوى في الصفحة رقم 10
6 Push or pull the blue tab located near the front of the system and slide the system into the rack. Tighten the thumbscrews to secure the ears of system to the front of the rack. Optional – Connecting the Keyboard, Mouse, and Monitor Connect the keyboard, mouse, and monitor (optional). The connectors on the back of your system have icons indicating which cable to plug into each connector. Be sure to tighten the screws (if any) on the monitor's cable connector. 8 Getting Started With Your Sy
ملخص المحتوى في الصفحة رقم 11
Connecting the Power Cable(s) Connect the system’s power cable(s) to the system and, if a monitor is used, connect the monitor’s power cable to the monitor. Plug the other end of the power cables into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU). Securing the Power Cable(s) Release the latch on the retainer unit and pull the clamping ring towards the end of the strip. Open the clamping ring and insert t
ملخص المحتوى في الصفحة رقم 12
Turning On the System Press the power button on the system and the monitor. The power indicators should light. Complete the Operating System Setup To install an operating system, see the installation and configuration documentation for your operating system. Be sure the operating system is installed before installing hardware or software not purchased with the system. 10 Getting Started With Your System
ملخص المحتوى في الصفحة رقم 13
Supported Operating Systems ® ® Red Hat Enterprise Linux 5.4 Standard edition (x64) Red Hat Enterprise Linux 5.4 Standard edition (x86) ® SUSE Linux Enterprise Server 11 (x86_64) ® Citrix XenServer™ Enterprise edition 5.x ® VMware ESX Server Version 4.0, Update 1 NOTE: For the latest information on supported operating systems, see support.dell.com. Other Information You May Need WARNING: See the safety and regulatory information that shipped with your system. Warranty information ma
ملخص المحتوى في الصفحة رقم 14
Technical Specifications Processor ® ® Processor type One or two Intel Xeon 5500 or 5600 series processors (up to six core processors) Expansion Bus Bus type PCI Express Generation 2 Expansion slots PCIe One x16 half-length, full height Mezzanine/Daughter slots PCIe Two x4 custom slots Memory Architecture 1067 and 1333 MHz DDR-3 registered memory modules with Error Correcting Code (ECC) Memory module sockets Eighteen 240-pin DIMMs Memory module capacities 2 GB, 4 GB, or 8 GB Minimum RAM 12 G
ملخص المحتوى في الصفحة رقم 15
Connectors Back NIC Two RJ-45 (for integrated 10/100/1000 Mbps Ethernet) KVM over IP port Dedicated Ethernet port for remote management access Serial 9-pin, DTE, 16550-compatible USB Two 4-pin, USB 2.0-compliant Video 15-pin VGA Front USB (for 3.5-inch chassis only) Two 4-pin, USB 2.0-compliant Video Video type AST2050 video controller; VGA connector Video memory 8 MB Power AC power supply (redundant and non-redundant) Wattage 650 W Voltage 115–230 VAC, 50/60 Hz, 8/4 A Heat dissipation 2217.8
ملخص المحتوى في الصفحة رقم 16
Physical Height 70.6 cm (27.8 in) Width 43 cm (16.9 in) Depth 4.3 cm (1.6 in) Weight (maximum configuration) 18.5 kg (40.7 lb) Weight (empty) 6.8 kg (14.9 lb) Environmental For additional information about environmental measurements for specific system configurations, see www.dell.com/environmental_datasheets. Temperature Operating 10° to 35°C (50° to 95°F) with a maximum temperature gradation of 10°C per hour NOTE: For altitudes above 2950 feet, the maximum operating temperature is derated
ملخص المحتوى في الصفحة رقم 17
Environmental (continued) Maximum shock Operating One shock pulse in the positive z axis (one pulse on each side of the system) of 31 G for 2.6 ms in the operational orientation Storage Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 71 G for up to 2 ms Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 32 G fair squared wave pulse
ملخص المحتوى في الصفحة رقم 18
16 Getting Started With Your System
ملخص المحتوى في الصفحة رقم 19
Dell™ PowerEdge™ C1100 Guide de mise en route Modèle réglementaire CS24-TY
ملخص المحتوى في الصفحة رقم 20
Remarques, précautions et avertissements REMARQUE : une REMARQUE indique des informations importantes qui peuvent vous aider à mieux utiliser votre ordinateur. PRÉCAUTION : une PRÉCAUTION vous avertit d'un risque d'endommagement du matériel ou de perte de données en cas de non-respect des instructions données. AVERTISSEMENT : un AVERTISSEMENT vous avertit d'un risque d'endommagement du matériel, de blessure corporelle ou de mort. ____________________ Les informations contenues dans ce docu
