ملخص المحتوى في الصفحة رقم 1
DNR / DWDR / IR
NVD Bullet Camera
with 4-Axis Mounting Arm
Installation Manual
3 Cameras in 1:
EV-1726-NKGQ (NTSC)
2.8~12mm
EV-1726-PKGQ (PAL)
EV-1726-NWGQ (NTSC)
6~50mm
EV-1726-PWGQ (PAL)
1
/ ” Sony Super HAD II CCD OSD with service monitor port
3
12VDC/24VAC 600 TV lines
NVD Bullet Cameras have an ultra-low Lux rating of 0.00006 allowing the
camera to see in almost total darkness.
Note: Products with model numbers that end with “Q” or that have a round green “Q
ملخص المحتوى في الصفحة رقم 2
ENFORCER DNR / DWDR / IR NVD Bullet Camera with 4-Axis Mounting Arm Specifications: EV-1726-NKGQ (NTSC) EV-1726-NWGQ (NTSC) EV-1726-PKGQ (PAL) EV-1726-PWGQ (PAL) Type IR LED Bullet Camera 1 Pickup Element /3” Sony Super HAD II CCD Resolution 600 TV lines Lens (DC Auto Iris) 2.8~12mm 6~50mm # of Infrared LEDs 56 (850nm) NTSC 768x494 pixels Effective Pixels PAL 752x582 pixels Video Output 1Vp-p composite video, 75Ω Minimum Illumination 0.00006 Lux (LEDs on) 0.05 Lux (LED
ملخص المحتوى في الصفحة رقم 3
ENFORCER DNR / DWDR / IR NVD Bullet Camera with 4-Axis Mounting Arm Overview: Mounting screw Sunshield Hex screw Rubber grommet Mounting plate 4-Axis mounting arm BNC connector Zoom Service Mounting base monitor port Focus Connect DC Jack DC plug with OSD joystick service monitor terminal block port connector Important: Do not cut DC jack or BNC connector as warranty will be voided. Before Starting: 1. Please read this manual carefully and keep it for 5. D
ملخص المحتوى في الصفحة رقم 4
ENFORCER DNR / DWDR / IR NVD Bullet Camera with 4-Axis Mounting Arm Troubleshooting Check that the camera is powered up. Check that the power supply’s polarity is correct. The screen is blank. Check that the monitor is powered up. Check that the video cable connecting the camera to the monitor is connected properly. Clean the lens using a soft, clean cloth. The screen image is dim. Check that the light source is adequate. Adjust the monitor’s contrast knob. The screen image