Samsung SCC/SNC-C7478 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

SCC/SNC-C7478 Installation Guide





SCC/SNC-C7478
Installation Guide
36x PTZ Dome Camera














SAMSUNG | GVI Security, Inc.
Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333 v.11.19.08

www.samsung-security.com

ملخص المحتوى في الصفحة رقم 2

SCC/SNC-C7478 Installation Guide 1. Remove junction box cover with supplied hex tool to view inner connection block. (figure 1a) Inner connection block exposes connections for power, video, alarm input/output as well as dip switches for selecting camera ID, protocol, baud rate and termination. (figure 1b) See manual for proper settings. 2. Attach wall mount to wall with supplied anchor bolts and make connections. 1a 1b Inner Box connections 2a RJ-45 Connection *Note for RS-485 Con

ملخص المحتوى في الصفحة رقم 3

SCC/SNC-C7478 Installation Guide Safety Cable 9. Attach fan and heater cables inside upper housing and attach dome cover safety cable. (figure 9a) Fan/heater cable 10. Return PTZ camera mechanism into upper housing by pressing the two black handles until camera mechanism snaps into place. (figure 10a) 9a 11. Close the dome cover by matching the arrow markers. Be sure internal cabling does not obstruct camera’s movement. 12. Orientation of housing my be adjusted by rotatin

ملخص المحتوى في الصفحة رقم 4

SNC-C7478 Setup Guide IP Setup Guide 36x PTZ IP Dome Camera SNC-C7478 1a 1. Plug the included cross-over cable into the RJ-45 jack located inside the inner connection block. (figure 1a) 2. Plug the other end of the cross-over cable into the RJ-45 jack on back of your computer. (figure 2a) 3. From included CD, run the application titled IPInstaller. This will open a window and scan your computer to locate the default IP address and subnet mask assigned to the IP dome. (figure 3a) 2

ملخص المحتوى في الصفحة رقم 5

SNC-C7478 Setup Guide 7a 7. Double click on Local Area Connection to bring up the Local Area Connection Status box. (figure 7a) Click Properties in the lower left corner to display Local Area Connection Properties. 8a 8. From the Local Area Connection Properties window, double click Internet Protocol (TCP/IP) to display Internet Protocol (TCP/IP) Properties. (figure 8a) 9. Choose the option for Use the Following IP Address and type an IP address that begins with 192.168.1. but use