Pelco PV1016RN دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

™
PelcoVision PV1000 Series
Quick Start Guide
INTRODUCTION
The purpose of this document is to provide the experienced CCTV/electronics user a logical quick start to the PelcoVision™ Phone
Line Transmission System. This document will detail the minimum steps necessary to transmit and receive video using the
PelcoVision™ system. For detailed installation, programming and operating instructions refer to the PelcoVision™ I/O Manual
(C1913M).
Recommendations
PSTN Models: Pelco does not recommend usin

ملخص المحتوى في الصفحة رقم 2

n Set the DIP switches on the rear of the PV110 modem according to the table below. PV110 Modem DIP Switch Settings 123 45678 ON ON OFF OFF ON ON OFF OFF n Connect the modem or terminal adapter to the Receiver using the supplied cable. n Connect the Receiver to an approved power source. n Connect a monitor to either monitor output. n Connect phone line(s) and power supply to the modem or terminal adapter. Programming a Transmitter Number for Call-up Switch power ON to the Modem/Terminal Ada

ملخص المحتوى في الصفحة رقم 3

SETTING UP A TRANSMITTER TO RECEIVE A CALL This section details the minimum steps necessary to set up a Transmitter for transmission of video to a Receiver. Refer to Figure 3 when setting DIP switches and making cable connections to the PV1016T. SW 1 SW 2 PV1016T REAR B COM 1 COM 2 KEYBOARD HI B HI B HI B HI B HI B HI B HI B HI B SW1 SW2 12 34 5 6 78 LO LOOP LO LOOP LO LOOP LO LOOP LO LOOP LO LOOP LO LOOP LO LOOP MONITOR MODEM ALARM A CAMERA INPUT A1 MODEM PORT AC POWER Figure 3. PV1016T Rear P

ملخص المحتوى في الصفحة رقم 4

Back-to-back operation requires a “full handshake” null modem connection between Transmitter and Receiver. A null modem adapter is available at most electronics stores (check gender requirements for the adapter) or create your own null modem by wiring two female 25-pin D-sub connectors according to Figure 22 in the PelcoVision™ I/O Manual (C1913M). PV1004T AC POWER REAR CAMERAS SW1 SW2 MODEM ALARM COM 1 COM 2 123 4 CAMERA INPUT 1 SW 1 SW 2 MODEM PORT Figure 4. PV1004T Rear Panel Hardware Setup