Pelco EM1015U دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

C202M-B (4/99)
EM1009U/EM1015U/EM1900U
Enclosure Mounts
®
3500 Pelco Way, IMPORTANT SAFEGUARDS AND WARNINGS
Clovis, CA 93612-5699
Prior to installation and use of this product, the following WARNINGS should be observed.
USA
1. Installation and servicing should only be done by qualified service and installation personnel.
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150 2. Installation shall be done in accordance with all local and national electrical and mechani-
cal codes utiliz

ملخص المحتوى في الصفحة رقم 2

INSTALLATION To attach the mount, perform the following steps: 1. Determine the location where the mount is to be installed. CAUTION: Make certain that the mount- 2. Using the mount as a template, mark and drill holes in the mounting surface. ing surface is capable of supporting four times the full 3. Bring the wiring in from the cable hole in the mounting plate or the side of the mount near load of the mount, enclosure, the mounting plate and through the mount arm. and camera. 4. Attach the mo

ملخص المحتوى في الصفحة رقم 3

SPECIFICATIONS Construction: Aluminum Finish: Gray polyester powder coat Maximum Load: 40 lb (18 kg) Pan Adjustment: 360° Tilt Adjustment: ±75° Locking Method: 3/8-16 hex bolts Enclosure Mounting: Two 1/4-20 x 0.625-inch (1.588 cm) hex bolts (provided) Suggested Mounting Method: Secure to solid surface with four 1/4-20 fasteners (not provided) Unit Weight EM1009U: 1.98 lb (0.90 kg) EM1015U: 2.43 lb (1.10 kg) EM1900U: 2.83 lb (1.28 kg) Dimensions: See Figure 1 and Figure 2 (Design and product spe

ملخص المحتوى في الصفحة رقم 4

ø 6.00 15.46 (15.24) (39.27) 3/8-16 x .50 (1.27) BOLT 4.28 (10.87) 4.95 (12.57) 14.98 (38.05) NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES 1.00 (2.54) 1.00 (2.54) ø 1.00 (2.54) Figure 2. EM1900U Dimension Drawing WARRANTY AND RETURN INFORMATION WARRANTY If a warranty repair is required, the Dealer must contact Pelco at (800) 289-9100 or (559) Pelco will repair or replace, without charge, any merchandise proved defective in material 292-1981 to obtain a Repair Authorizati