ملخص المحتوى في الصفحة رقم 1
Instruction Manual
www.winegard.com/pathway
For receivers and programming, call 1-866-609-9374
For up-to-date information on receiver compatibility and programming,
visit www.winegard.com/receivers
For help, email help@winegard.com or call 1-800-788-4417
Do not return antenna to place of purchase
2452314
ملخص المحتوى في الصفحة رقم 2
Quick Setup for One Receiver Compatible Satellites 1. Make sure the Pathway™ X1 antenna is in a location with a The Pathway X1 antenna can receive programming from DISH clear view of the southern sky. western arc, which includes satellites 110°, 119°, and 129°. 2. Connect the primary receiver to the “MAIN” port on the base. See maps below to determine coverage in various areas of the United States. Coverage maps are approximate and do 3. After connecting the receiver to a power source, compl
ملخص المحتوى في الصفحة رقم 3
A 25 foot coaxial cable is included and recommended for Warnings NOTE use with the antenna. Longer coax runs could potentially cause intermittent problems. Maximum cable length should never Do not place the unit in water greater than one inch deep, or exceed 50 feet. ! water may damage the electronics. 3. Select a location that will enable the Pathway X1 antenna to ! Do not install or operate the antenna in winds of 35 mph or sit within three degrees of level. The antenna may take longer g
ملخص المحتوى في الصفحة رقم 4
The receiver may reboot automatically as part of the update 4. 4. DISH Receiver Setup process. If so, select the state of your current location on the Mobile Antenna Setup screen as in figure 2. Press “Scan” to After connecting the antenna to the receiver(s), connect the begin the search routine. receiver to a power source, and complete receiver setup. 5. The satellite will search for and acquire satellites. Receiver setup for the primary receiver follows; if setting up with a secondary re
ملخص المحتوى في الصفحة رقم 5
Receiver Setup for Currently Active or Updating Receiver Software Previously Used Receivers For optimal performance, update receiver software occasionally. To allow the software to update, leave the satellite If the receiver you will be using with the Pathway X1 antenna on signal, and press the Power button on the remote or front is an older receiver that has not been used in several years, panel of the receiver; this will put the receiver in Standby you may need to connect the receiver to
ملخص المحتوى في الصفحة رقم 6
5. Select “Test” (see fig. 14). The receiver will then run through Receiver Setup for a Secondary Receiver a series of tests to install the proper satellite. The Check Switch test will install the satellite that the primary receiver is After completing setup on the main receiver, power on the receiving signal from. secondary receiver. If using a new receiver, you will be guided through the setup by the Installation Wizard; turn the primary Do not change channels on the primary receiver whe
ملخص المحتوى في الصفحة رقم 7
Troubleshooting On Screen Possible Cause Solution Mobile Antenna Setup does not appear • No communication between receiver • Check wiring. Verify connection to and satellite dish Main port. Verify good coax. • Receiver software not compatible • Ensure a compatible DISH Solo HD receiver is being used. • Connect receiver to fixed/home satellite dish for software update. Error Code 150, “All Satellites Not Found” • Possible obstructions blocking satellite • Attempt to move the antenna from • Sa
ملخص المحتوى في الصفحة رقم 8
WINEGARD MOBILE PRODUCTS LIMITED WARRANTY (2 YEARS PARTS; 1 YEAR LABOR) Winegard Company warrants this product against defects in materials or workmanship for a period of two (2) years from the date of original purchase. During year one (1) of such warranty, Winegard Company will also pay authorized labor costs to an authorized Winegard dealer to repair or replace defective products. No warranty claim will be honored unless at the time the claim is made, Customer presents proof of purchase t
