ملخص المحتوى في الصفحة رقم 1
DIRECTV
Digital Satellite Receiver
MENU
SELECT
POWER
MENU SELECT
POWER
Models GAEB0
GCEB0
1030674-0001 Rev. D
OWNER’S MANUAL
ملخص المحتوى في الصفحة رقم 2
Copyright © 2001, 2002 Hughes Network Systems, a Hughes Some pay per view programs may be licensed from producers as Electronics Corporation company. All rights reserved. This “view-only” programs. These are copyrighted programs, and may not publication and its contents are proprietary to Hughes Network be copied or reproduced for any purpose without the express written Systems, a Hughes Electronics Corporation company. No part of this permission of the copyright owner. publication may be rep
ملخص المحتوى في الصفحة رقم 3
Important Safety Instructions For your safety and protection, read this entire Owner's Manual before you attempt to install or use your satellite system. In particular, read this safety section carefully. Keep this safety information where you can refer to it if necessary. Heed Cautions–All cautions on the product and in the operating instructions should be adhered to. Follow Instructions–All operating and use instructions should be followed. THESE CAUTIONS AND SYMBOLS APPEAR ON THE BACK OF TH
ملخص المحتوى في الصفحة رقم 4
INSTALLATION Polarization – This DIRECTV Receiver is equipped with a plug that will Example of Antenna Grounding according to the National fit into the power outlet only one way. Do not modify the plug defeating this Electrical Code instructions contained in “Radio and Television feature. If the plug does not fit, contact your electrician to replace your Equipment”. outlet. To prevent electric shock, do not use this plug with an extension cord or outlet unless you can fully insert the blades
ملخص المحتوى في الصفحة رقم 5
SERVICE Servicing–Do not attempt to service this DIRECTV Receiver yourself as Use of replacement parts specified by the manufacturer can prevent fire, opening or removing covers may expose you to dangerous voltage or other electric shock, or other hazards. hazards. There are no user serviceable parts inside. Refer all servicing to Safety Check–Upon completion of any service or repairs to this qualified service personnel. DIRECTV Receiver, ask the service technician to perform safety checks C
ملخص المحتوى في الصفحة رقم 6
Federal Communications Commission (FCC) Regulatory Information Declaration of Conformity– Standards to which Conformity is declared: FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party’s Name: Hughes Network Systems Address: 11717 Exploration
ملخص المحتوى في الصفحة رقم 7
vi
ملخص المحتوى في الصفحة رقم 8
Contents Setting default and alternate audio . . . . . . . . . . 24 Getting started. . . . . . . . . . . . . . . . . . . . . . . . 1 Using Dolby Digital audio . . . . . . . . . . . . . . . . 24 Setup overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Using the Optimize setting . . . . . . . . . . . . . . . . 24 Attach the antenna cable . . . . . . . . . . . . . . . . . . . 2 Adjusting audio balance . . . . . . . . . . . . . . . . . . 25 Connect your TV. . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 9
viii Contents
ملخص المحتوى في الصفحة رقم 10
Getting started 1 This chapter explains how to: You may connect a second • Connect the DIRECTV satellite dish antenna to your DIRECTV Receiver DIRECTV Receiver to the unused (this page). LNB output. These instructions • Connect your DIRECTV Receiver to your TV (see page 3). also apply to an additional • Find antenna azimuth and elevation settings for your location (see page 4). receiver. • Test the DIRECTV System operation (see page 5). How to use this manual This manual uses these typograp
ملخص المحتوى في الصفحة رقم 11
You can configure your system several ways, depending on what additional Attach the antenna cable components (such as a VCR, DVD player, or A/V receiver) you select. For now, however, use the simplest configuration to check your antenna and cabling. • Ensure that the DIRECTV Receiver is not plugged into an electrical outlet. • Attach the RG-6 coaxial antenna cable to the SATELLITE IN connector on the back of the DIRECTV Receiver. Refer to the appropriate figure below and on the next page.
ملخص المحتوى في الصفحة رقم 12
Depending on your TV, you can connect it to the receiver in one of three ways: Connect your TV • S-Video cable (best picture quality) or • Video cable (very good picture quality) or • Coaxial cable (good picture quality) In addition to your video connection, use a set of audio cables (L/R) to provide stereo sound. If your TV does not have audio jacks, you will hear monophonic audio. This is acceptable for the procedures described in the next section. To connect your TV to the DIRECTV Receiver:
ملخص المحتوى في الصفحة رقم 13
This section explains how to determine the proper antenna position. This is Determine antenna expressed in degrees of azimuth (horizontal) and elevation (vertical). Use the angles receiver front panel controls shown below to complete this procedure.
1 1
& ; % !"& - 1. Press the front panel MENU button to display the MAIN MENU below. 2. Use the button to highlight the System Setup tab.
ملخص المحتوى في الصفحة رقم 14
When you have aligned your dish antenna to the azimuth and elevation angles Testing your system shown on the Install pane: 1. Highlight the Signal tab. 2. Use the button to highlight the Source pull-down menu 3. Signal quality is indicated by a scale at the bottom of the pane and with an audible indication. The frequency and tempo of the tone increase with signal strength. )-%),3-,9 ,"
00 $ !! ) ! ) !) " ( 3 )
,$+ /$ ) !! 00 :; ,
ملخص المحتوى في الصفحة رقم 15
3. Press SELECT again to test the first selection on the pop-up menu. )<),,),
0100 $ !! ) ! )*$ , $ $ ( 3 > , $ =+ , $ =+ , $ /$ , $ ) !! 00:; 10?@A ) !! 006:>; # @@@? ) !! 00: ; + .8 ! )<),,),
0100A 2
$ .8 $ !! ",( ) ! )*$ , $ $
( 3 > , $ =+ , $ /$ , $ , $ ) !! 00:;) !) " # + 0C 6 6 6 6
ملخص المحتوى في الصفحة رقم 16
Adding system components 2 You can configure your DIRECTV Receiver several ways depending on the additional audio/video components you want to use. This chapter explains how to: • Connect a terrestrial (broadcast) TV antenna (this page). • Connect the optional RF remote control antenna (this page). • Connect and set-up a VCR (see page 10). • Integrate the DIRECTV Receiver into your existing audio or A/V system (see page 12). Connecting At this point, you should have: components Verified that y
ملخص المحتوى في الصفحة رقم 17
Connecting a VCR Follow these instructions to connect your TV and VCR to the DIRECTV Receiver. Connect the satellite antenna RG-6 coaxial cable to the DIRECTV Receiver’s SATELLITE IN jack (refer to figures on page 3). 1. Depending on your VCR, select the appropriate connection to the DIRECTV receiver: If your VCR has A/V connectors – Connect the DIRECTV Receiver’s AUDIO and VIDEO jacks to the VCR’s A/V IN jacks. If your VCR only has an RF (coaxial) connector– Connect the DIRECTV Receiver
ملخص المحتوى في الصفحة رقم 18
8. Remove the temporary mounting tape. Attach the emitter permanently with peel-and-stick backing. This will not interfere with normal VCR operation. The VCR SETUP menu provides the settings to allow the DIRECTV Receiver to communicate with your VCR. ( 3), ,"
!0611 $ !! ) ! ( 3 > , $ /$ 3 ! 0 , $ ) + #! # ! & 1 +
* $ 2
$ ",( > !!'9# !!
>&$ A ? VCR SETUP menu pane 9.
ملخص المحتوى في الصفحة رقم 19
Connecting a home You can integrate the DIRECTV Receiver into your entertainment system to take advantage of enhanced audio and video capability. Follow these entertainment instructions to connect your DIRECTV Receiver. system • To connect the DIRECTV Receiver to your audio system, use A/V cables to connect the satellite receiver to the audio receiver’s AUDIO IN jacks. The A/V receiver must be turned • Dolby Digital - With the GCEB0 model, you can enjoy programs that on in order to send th
ملخص المحتوى في الصفحة رقم 20
Using the remote control 3 This chapter explains how to: • Use the HMRC-8 and HMRC-9 remote control functions. (see page 15) • Install and replace the remote control batteries. (see page 16) • Program the remote to work with your system components. (see page 16) • Access interactive programming features. (see page 17) # 3 %
"//@ -A. %
"//. ! " &
,
, -
