Kidco HEARTHGATE G70 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Patent:
5,890,320
KidCo is a member of:
User Guide
HearthGate Model G70
Made in Denmark for: www.kidco.com
For hearths 6’ wide by 2’ deep
KidCo, Inc. Phone 847-970-9100
300 Terrace Drive Fax 847-970-9109
Optional 8” section (G70-8) or 24” section (G70-24)
Mundelein, IL 60060
available for larger areas.
Patents pending
Bl. 3001-101d • G70-0208

ملخص المحتوى في الصفحة رقم 2

Important Notes Parts Check List a stable surface. Familiarize yourself with the FOLLOW THESE parts by comparing them to the parts check 2 list below. INSTRUCTIONS It is recommended you place the gate a mini- mum of 20” from the source of heat/fire. CAREFULLY AND Standard HearthGate™ has WARNING five 24” sections including a 2 Wall Plates (C) KEEP THEM FOR At 20” away from the source of heat/fire, the walk through door gate could reach a temperature of 130˚. Since FUTURE every fireplace/wood

ملخص المحتوى في الصفحة رقم 3

Unpacking Assembly Unpack your folded HearthGate™ on a Removing or adding sections: 1. 5. stable surface, making sure handle is on top. Note: Always begin separating gate from Each corner is connected by plastic, inter- either end. At the juncture of every section is locking hinges. a removable, vertical bar. How to adjust the sections: To remove vertical bar, lift up on bar (5), while 2. 6. 2. 1. 6a. 3. A spring is fitted in all cones which delib- sliding it out of lower hinge groove (6a.). Pul

ملخص المحتوى في الصفحة رقم 4

Assembly Installation Remove hinge cap (H) from bottom of original Installing the wall mountings: 9. 13. end section. A screwdriver may be needed to Fold wall cover (A) around vertical bar at end pry it off. Place under bottom hinge. Remove of gate. plastic cone from under top hinge of original A end section. Install cone (I) under top hinge of new end section. H I Insert lock fitting (B). Reinstall a removable, vertical bar. Insert bar 10. 14. A 10a. by pressing it into upper hinge cone, while

ملخص المحتوى في الصفحة رقم 5

Installation Installation Center buttons of assembly with wall plate Remove wall plate (C) from assembly by 17. 21. 21a. holes (17. a). When aligned, push buttons pressing locking tab (21a.) and lifting it off. through holes and slide down to lock (17. b a bc & c). Buttons C Note: Screws provided are for mounting Now it should look like this. 18. 22. directly into wood. If mounting into brick, D drywall or other surfaces, use appropriate hardware. Hold wall plate (C) inside outline and screw in

ملخص المحتوى في الصفحة رقم 6

KIDCO LIMITED WARRANTY Operation Your KidCo product is warranted to be free from manufacturing defects for a period of one year from date of purchase under normal non commercial use and in compliance with the Opening the walk through door: 25. operating instructions. This warranty extends only to the original retail purchaser and is only Squeeze handle up as much as possible (1). valid when supplied with proof of purchase. The locking bar should release from bottom frame (2). KidCo will either r