ملخص المحتوى في الصفحة رقم 1
™
Prowler 710
Robotic Inground Pool Cleaner
Installation
and
User's Guide
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
ملخص المحتوى في الصفحة رقم 2
Customer Service If you have questions about ordering Pentair replacement parts, and pool products, please use the following contact information: Customer Service (8 A.M. to 5 P.M. — Eastern and Pacific Times) Phone: (800) 831-7133 Fax: (800) 284-4151 Technical Support Sanford, North Carolina (8 A.M. to 5 P.M. — Eastern Time) Phone: (919) 566-8000 Fax: (919) 566-8920 Moorpark, California (8 A.M. to 5 P.M. — Pacific Time) Phone: (805) 553-5000 (Ext. 6312) Fax: (805) 553-5515 Web site visit www.pe
ملخص المحتوى في الصفحة رقم 3
i Contents Important Safety Precautions..............................................................................................ii Section 1: Introduction .....................................................................................................1 ™ Prowler 710 Overview ...........................................................................................1 ™ Prowler 710 Features ............................................................................................2 Sect
ملخص المحتوى في الصفحة رقم 4
ii IMPORTANT SAFETY PRECAUTIONS Important Notice: Attention Installer: This guide contains important information about the installation, operation and safe use of this product. This information should be given to the owner and/or operator of this equipment after installation of the pool cleaner. Attention User: This manual contains important information that will help you in operating and maintaining this pool cleaner. Please retain it for future reference. Consult Pentair Water with any questio
ملخص المحتوى في الصفحة رقم 5
1 Section 1 Introduction ™ The Prowler 710 Overview Automatically clean your pool in 60 to 90 minutes or less ™ The fastest and most effective robotic cleaner in its class, the Prowler 710 features true “plug and play” convenience. It operates totally independently of your pool’s circulation system to cover and clean any dimension, form, or shape of inground pool up to 50 feet in length. A Jet Drive propulsion system with a single, powerful motor drives the cleaner and enables the cleaner to rol
ملخص المحتوى في الصفحة رقم 6
2 General Features ™ The Prowler 710 features three-way cleaning performance: • Dual pressure wash jets lift sand, silt and algae off floors and walls – including surface pores where brushes can’t reach. • Powerful vacuum action removes fine particles and larger debris. • Internal filtration system removes contaminants and bacteria as small as two microns. • No installation, no booster pump, no hoses, and fully automatic. Additional Features: Time and energy-saving features: • Reduces your filtr
ملخص المحتوى في الصفحة رقم 7
3 Section 2 Set-up ™ The following general information describes how to set-up your Prowler 710 robotic pool cleaner. Carefully read the following so that you are fully aware of all the capabilities and features this cleaner has to offer. NOTE: Before setting up this product, read and follow all warning notices and instructions starting on page ii. ™ Introducing your new Prowler 710 Cleaner Dear Customer, Congratulations! You have purchased one of the best pool cleaners that technology has to o
ملخص المحتوى في الصفحة رقم 8
4 ™ How your Prowler 710 Cleaner works The patented built in pump motor provides the power for your cleaner’s jet drive propulsion and hydroscrubbing jets. The hydroscrubbing jets, directed at the pool surface under your cleaner, stir up dirt and debris for easy vacuuming by the cleaner’s suction power. All dirt from leaves to algae is collected in the internal filter bag for easy removal. A simple patented axle tilting system allows your cleaner to alternate between straight and curved movement
ملخص المحتوى في الصفحة رقم 9
5 Setting up your Prowler™ 710 Cleaner Your new cleaner consists of two main parts: A. Power Supply (Transformer) with Two-Hour Automatic Shut-Off, Figure 1. Fuse Holder Forward/Reverse Timer Control Dial Power Supply Cord Socket (for Floating Cable) Power (ON/OFF) Switch Reset Button NOTE: The Power Supply appearance may vary and features may be located in different positions then what is shown above. Rear view Front view 6 Figure 1. B. Pool Cleaner with Floating Cable, Figure
ملخص المحتوى في الصفحة رقم 10
6 Setting up the Power Supply WARNING —Risk of electrical shock or electrocution. A ground fault current interrupter (GFCI) must be in place to protect your electric outlet . Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa users, installers, or others due to electrical shock, and may also cause damage to property. The power supply MUST be placed a minimum distance of 10 feet away from the pool. Failure to do so could create an elec
ملخص المحتوى في الصفحة رقم 11
7 Placing the Cleaner into the Pool WARNING —Risk of electrical shock or electrocution. The power supply MUST be placed and a minimum distance of 10 feet away from the pool. Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa users, installers, or others due to electrical shock, and may also cause damage to property. 1. Place the cleaner in the pool upside down, gently tilting it side to side to allow any trapped air to escape. Once th
ملخص المحتوى في الصفحة رقم 12
8 Adjusting the Timing Cycle The Time Control Dial located on the front panel of the Power Supply can be adjusted to allow more or less time between the cleaner's forward and reverse motion, see Figure 8. Set your cleaner's Time Control Dial to 30 seconds. The goal is to have your cleaner move across your pool at its widest point, from one side to the other and wait at both sides for approximately 2 seconds before reversing. If this doesn't happen adjust the Time Control Dial accordingly. NOTE:
ملخص المحتوى في الصفحة رقم 13
9 The Cleaning Motion in the Pool The size of your pool, and the amount of debris in it, will determine the length of time required to clean the pool. The time required may vary up to two hours. If the cleaner typically reaches the waterline at each side as it is supposed to, but begins to slow down considerably (constantly reverses direction before reaching the sides of the pool) or is unable to climb the walls of the pool, it is sending a signal that it’s time to clean the Filter Bag. Removing
ملخص المحتوى في الصفحة رقم 14
Short Side 10 Cleaning or Changing the Filter Bag 1. Make sure that the Power Supply is turned Lock Tabs “OFF” and that the cleaner's Floating Cable is unplugged from the Power Supply. Place the cleaner on its back on a non-abrasive surface and release the two Lock Tabs, (located on the sides of the unit), see Figure 11. Using your thumbs, push the Lock Tabs away from the center of the cleaner to unlock the Bottom Lid Assembly one Lock Tab at a time, see Intake Valve Flaps Figure 12. Remove th
ملخص المحتوى في الصفحة رقم 15
11 In-Season Storage WARNING — Do not allow swimmers in the pool while your pool cleaner is in the pool. Cable can trip or entangle swimmers which could result in drowning. Do not leave your cleaner in the pool when not in use. Doing so, will reduce the life of your Filter Bag and cleaner. After removing your cleaner from the pool you should clean and re-install the Filter Bag. Then, rest your cleaner on all four wheels in a dry, shaded area along with its Power Supply and properly coiled Float
ملخص المحتوى في الصفحة رقم 16
12 ™ Prowler 710 Installation and User’s Guide
ملخص المحتوى في الصفحة رقم 17
13 Section 3 Troubleshooting Use the following troubleshooting information to resolve possible problems with your Prowler™ 710 pool cleaner. Problem Corrective Action Slower motion or inefficient vacuuming. Check to see if the Filter Bag is thoroughly clean. FYI: The Fine Filter Bag is capable of filtering particles 20 times smaller than the naked eye can see. Therefore, thorough cleaning of the bag may be required! NOTE: Use the Fine Filter Bag to trap smaller debris such as algae, bacteria, sa
ملخص المحتوى في الصفحة رقم 18
14 Problem Corrective Action Does not reverse direction. Take a garden hose with high pressure, spray into the Valve Housing at each Valve Port opening, (Figure 2, Item 9). This should free the Jet Valve System of any debris. If this does not solve the problem, firmly grab hold of both of your cleaner’s Handles (Figure 2, Item 5) and forcefully dunk the cleaner in and out of the pool several times to flush out the dirt causing the problem. If debris is still lodged (such as sand or dirt) or ther
ملخص المحتوى في الصفحة رقم 19
15 Figure 17. Figure 19. Figure 20. Figure 18. ™ Prowler 710 Installation and User’s Guide
ملخص المحتوى في الصفحة رقم 20
16 Section 4 Replacement Parts ™ Prowler 710 Model 3 8 36 20 21 35 21 36 20 37 13 21 19 27 31 35 30 25 21 28 4 26 22 26 15 25 23 10 29 9 22 11 37 28 2 16 12 15 32 34 14 17 33 14 11 13 9 35 10 15 16 15 18 23 22 22 34 1 21 21 5 21 20 36 21 24 7 35 20 36 6 17.0" 12.0" 20.1" ™ Prowler 710 Installation and User’s Guide
