Code Alarm CSM-3 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Remote Vehicle Starter
CSM-3
Owner's Manual
INS0916
Rev. A
6/99

ملخص المحتوى في الصفحة رقم 2

Table of Contents How the CSM-3 Operates ........................................................................... 3 Starting the Vehicle with the Remote Starter ............................................ 3 Stopping the Vehicle While It Is Running Via the Remote Starter ............ 4 Operating Your Vehicle While the CSM-3 is Engaged ............................... 4 Engaging the CSM-3 When Exiting Your Vehicle ....................................... 4 Status Indication .....................

ملخص المحتوى في الصفحة رقم 3

How the CSM-3 Operates The CSM-3 functions as a keyless entry Press to Lock Press to Unlock system and a remote vehicle starter. All All Doors All Doors features of the CSM-3 are controlled through the supplied remote transmitters. Press to Open Press to Start Trunk / Hatch or Stop Vehicle Starting the Vehicle with the Remote Starter Press the START button on the remote transmitter. The parking lights will flash one time to confirm that the vehicle is about to start. The CSM-3 will energize the

ملخص المحتوى في الصفحة رقم 4

Stopping the Vehicle While It Is Running Via the Remote Starter The vehicle will instantly shut down if any of the following occurs while it is running via the remote starter: • The START button on the remote transmitter is pressed. • The vehicle brake pedal is pressed before the ignition key is turned to the ON position. • The vehicle hood is opened before the ignition key is turned to the ON position. • The engine is "revved" at or near 3000 RPM. Operating Your Vehicle While the CSM-3 is Eng

ملخص المحتوى في الصفحة رقم 5

System Maintenance Changing the Remote Transmitter Battery The 12-volt alkaline battery supplied in your remote transmitter should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter will operate. Follow the instructions below to change the remote transmitter battery. 1. Remove the screw (if equipped) on the back of your remote transmitter. 2. Use a small coin or sc

ملخص المحتوى في الصفحة رقم 6

System Maintenance Programming Keyless Entry Characteristics 1. Press and hold the brake pedal. Turn the ignition on and off four (4) times, then release the brake pedal. If done correctly, the unit will respond by flashing the parking lights four (4) times. (From inside the vehicle, you will hear four (4) ‘clicks’ from the module.) This indicates that the unit has entered the programming mode. 2. Press the LOCK button (button 1) on a programmed Button 1 Button 2 transmitter to begin option sele

ملخص المحتوى في الصفحة رقم 7

CODE-ALARM, INC. LIMITED LIFETIME WARRANTY A CODE-ALARM, INC. (“CODE”) vehicle security system sold to a retail consumer purchaser by an authorized dealer of CODE and installed by an authorized dealer of CODE is warranted by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the security system was originally installed. A CODE vehicle security system sold to a retail consumer purchaser by an authorized deal

ملخص المحتوى في الصفحة رقم 8

8