Audiovox Prestige Platinum 128-8120 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Model APS 687a
Owner’s Manual
7 Channel Remote
Car Starter
FEATURES :
2 Five Button Programmable RF Transmitters
Seven Channel Receiver (capable of accepting 4 transmitters)
Code Hopping Technology
Combination Remote Start Safety Control/Valet/Programming Push-
Button LED Switch
Safe Start RF Control (Double Push Of RF Transmitter)
Selectable Automatic Timed Start Mode
( + ) and ( - ) Keyless Entry Outputs
On-Board Start Relay
On-Board Accessory Relay
3 On-Board Ignition Relays
On-

ملخص المحتوى في الصفحة رقم 2

YOUR “CODE HOPPING“ TRANSMITTERS The transmitters included with your new remote start system use the most advanced and secure form of radio frequency transmission available on any current automotive remote system. Some of today’s sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and re- transmit at a later time to unlock your system. Your code hopping transmitters will change their signal every time the button

ملخص المحتوى في الصفحة رقم 3

Note: The feature that has been added to channel 3 will always be activated using the same transmitter button that remotely starts the vehicle. There is no way to move the channel 3 function to a different transmitter button. ADDITIONAL REMOTE FUNCTION (CHANNEL 4) This system has an additional feature that can be connected to a number of different optional accessories. Some of the more common uses for this channel are: Can Be Set Up To Activate Rear Window Defogger During Remote Start If V

ملخص المحتوى في الصفحة رقم 4

PRLED SAFETY CONTROL SWITCH The Pushbutton LED control switch allows you to temporarily disable the remote starting function of the system. This recommended whenever the vehicle is being serviced. To place the system in the service mode: 1) With the system disarmed/unlocked, and the ignition switch off Press and Hold the PRLED on. 2) Turn the ignition switch on, off, on, off, on, off. 3) The LED begins to flash two short flashes followed by one long flashes and continues this pattern until retu

ملخص المحتوى في الصفحة رقم 5

starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if the car is garaged. To Remote Start The Vehicle: Press and release the trunk/key button of your keychain transmitter two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15 or 20 minutes. As a visual indication, the parking lights will flash or turn on dependent on the programming

ملخص المحتوى في الصفحة رقم 6

3. Within 10 seconds of step 2, activate the RF start command two times. (Push the trunk/key button of your keychain transmitter 4 times). The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated. CANCELING THE AUTOMATIC START UP TIMER To cancel the automatic start up timer do one of the following; 1. Start the vehicle manually with the use of the ignition key and depress the brake pedal. 2. Remote start the vehicle using your keychain RF transm

ملخص المحتوى في الصفحة رقم 7

THIS PAGE LEFT BLANK INTENTIONALLY Page 7 128-8120 7 of 8

ملخص المحتوى في الصفحة رقم 8

© 2007 Audiovox Electronics Corporation, Hauppauge, NY 11788 128-8120 Page 8 128-8120 8 of 8