ملخص المحتوى في الصفحة رقم 1
Model APS-920
Owner’s Manual
ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors,
hood lid and trunk lid.
2. Press and release Lock/Arm button on the keychain
transmitter.
The dash mounted LED begins to flash slowly. Parking
Lights flash one time.
Siren sounds one chirp.
If the siren/horn sounds 3 chirps, then you have left a door,
trunk, or hood lid ajar. Simply close the opened entry point
to provide full protection. If the siren "chirped" three times,
s
ملخص المحتوى في الصفحة رقم 2
WHILE THE SYSTEM IS SOUNDING If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the Unlock/Disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children playing near your vehicle that may accidently trigger your security system. In this case you can cancel the siren sounding without di
ملخص المحتوى في الصفحة رقم 3
If the new code was accepted, the unit will report back the newly entered code, by flashing the LED, first indicating the 10ths digit, pause and then the units digit. The unit will report the new code three times with a one second pause between each code, then the system will begin arming. If the LED flash pattern reports the previously stored code, the new code was not entered correctly. Please repeat steps 1 through 7 above considering the following. NOTE: Acceptable digits 10ths or units a
ملخص المحتوى في الصفحة رقم 4
characters hanging about your vehicle. To access this mode, while within range of your car, simply press and hold either the lock or unlock button of your transmitter for three seconds. The parking lights will begin to flash, the siren will sound, and if connected, the vehicle horn will beep making your vehicle audible as well as more visible. The lights, siren and or horn will stop automatically after 30 seconds. If you wish to turn off this mode prior to the expiration of the 30 second ti
ملخص المحتوى في الصفحة رقم 5
button for two seconds. If you find the normal arming and disarming chirps annoying, they can be turned off permanently, eliminating the need to hold the ARM / DISARM button for 2 seconds. To do this, 1. Turn the ignition key on then off. 2. Within 10 seconds, press and release valet switch three times. 3. If the chirps were on before you started, then you will hear two chirps indicating they have been turned off. If the chirps were off before you started, then you will hear one chirp indicatin
ملخص المحتوى في الصفحة رقم 6
the device indicated, momentarily press, or press and hold the appropriate transmit- ter button(s) as indicated above. TURBO TIMER MODE This system provides a means to cool down the vehicles turbo charger, if so equipped, by allowing the vehicle to continue to run for a prescribed period of time every time the vehicle's engine is turned off. This feature requires the system to be set up for turbo timer during installation. Consult with your installation center to be certain this feature was ac
ملخص المحتوى في الصفحة رقم 7
1) Enter the transmitter program mode of channel 1 as indicated above. 2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a chirp, then release and immediately press the same button a second time until you hear a long chirp followed by a short chirp. This action erases the transmitter. If the transmitter you wish to erase has been lost or stolen then following the information below will successfully remove the transmitter. NOTE: For this procedur
ملخص المحتوى في الصفحة رقم 8
Vehicle as Been Started By Remote Control. Vehicle Is Running Under Control of The Remote Start Unit. Battery Save Mode Is On. Battery Level Indicator, Shown At Full Level. Hood Or Trunk Input Was Activated. Door Input Was Activated. Vibration Sensor Was Activated. Pre Detect Stage Of Sensor Was Activated. 128-7852A 8 of 10
ملخص المحتوى في الصفحة رقم 9
CAUTION!! CARBON MONOXIDE GAS CAN CAUSE SERIOUS INJURY AND EVEN DEATH It is the sole responsibility of the user to operate the vehicle this system is installed in a safe manner. This device must not be used in an enclosed space like a garage, attached or de- tached, car port, or any partially enclosed areas. Also this device must be placed in the service mode when dropping the vehicle off for service to prevent injury to the service technician. 128-7852A 9 of 10
ملخص المحتوى في الصفحة رقم 10
ORDER FORM FOR APS620CF & APS920CF2 Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the infor- mation legibly and mail this form and your payment according to the instructions below. Note: Transmitter model number found on back of case. APS620CF APS920CF2 1) Transmitter Model Number_____________________ 2) Name: _______________________________________ 3) Address: ______________________________________ 4) City: ________________ State:
