ملخص المحتوى في الصفحة رقم 1
OF OFF
O OF FF
O OF FF F O OF FF F
OOF F FF
O OFF FF O OF FF F O OF FF F
INSTALLATION INSTRUCTIONS
36" (91.4 CM) CLASSIC COMMERCIAL STYLE
DUAL FUEL CONVECTION RANGE
for residential use only
Table of Contents............................................................................................................2
IMPORTANT:
Save for local electrical inspector's use.
W10044930B
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS RANGE SAFETY .............................................................................2 Install Anti-Tip Bracket.................................................................8 Make Electrical Connection .........................................................9 INSTALLATION REQUIREMENTS ................................................4 Attach Backguard or Island Trim ...............................................10 Tools and Parts .......................................
ملخص المحتوى في الصفحة رقم 3
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS: Do not try to light any appliance. • Do not touch any electrical switch. � Do not use any phone in your building. � Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier'
ملخص المحتوى في الصفحة رقم 4
INSTALLATION REQUIREMENTS Parts needed ■ A UL listed or CSA approved conduit connector T ools and Parts Gather the required tools and parts before starting installation. ■ UL listed wire connectors Read and follow the instructions provided with any tools listed Check local codes and consult gas supplier. Check existing gas here. supply and electrical supply. See “Electrical Requirements” and Tools needed “Gas Supply Requirements” sections. It is recommended that all electrical connections be
ملخص المحتوى في الصفحة رقم 5
O OF FF F O OF FF F O OF FF F O OF FF F O OF FF O OF FF F O OF FF F O OF FF F Mobile Home - Additional Installation Requirements Cabinet Dimensions The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 Cabinet opening dimensions shown are for 25" (64 cm) (formerly the Federal Standard for Mobile Home Construction countertop depth, 24" (61 cm) base cabinet depth and and Safety, Title 24, HUD Part 280). When such standard
ملخص المحتوى في الصفحة رقم 6
Electrical Requirements Gas Supply Requirements If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that WARNING the ground path and wire gauge are in accordance with local codes and that the ground path is adequate. Check with a qualified electrical installer if you are not sure the range is properly grounded. Do not use an extension cord. Make sure that the electrical connection and wire size are adequate and in conformance
ملخص المحتوى في الصفحة رقم 7
Gas Supply Line Gas Pressure Regulator ■ Provide a gas supply line of ¾" (1.9 cm) rigid pipe to the The gas pressure regulator supplied with this range must be range location. A smaller size pipe on longer runs may result used. The inlet pressure to the regulator should be as follows for in insufficient gas supply. Pipe-joint compounds that resist proper operation: ®† the action of LP gas must be used. Do not use TEFLON Natural Gas: tape. With LP gas, piping or tubing size can be ½" (1.3 cm)
ملخص المحتوى في الصفحة رقم 8
INSTALLATION INSTRUCTIONS Unpack Range Install Anti-Tip Bracket WARNING WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. 1. Remove shipping materials, tape and protective film from range. Keep shipping pallet under range. Remove oven racks, grates and parts package from inside oven. Tip Over Hazard 2. Remove the 2 screws on each side of the top of the bottom A child or adult can tip the range and be killed.
ملخص المحتوى في الصفحة رقم 9
4. Using the final measurement from Step 3, measure from the 5. Tighten screws on conduit connector. floor up and mark a horizontal line on the wall where a wall 6. See “Electrical Connection Options Chart” to complete stud is located. installation for your type of electrical connection. A Electrical Connection Options Chart B If your home has: Go to Section: D 4-wire 4-Wire Cable from Home C Power Supply ½" (1.3 cm) A. Horizontal line marked from Step 4. 3-wire 3-Wire Cable from Home B. Wal
ملخص المحتوى في الصفحة رقم 10
3-Wire Cable from Home Power Supply Attach Backguard or Island Trim IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. WARNING Excessive Weight Hazard A Use two or more people to move and install range. B C Failure to do so can result in back or other injury. G H 1. Using 2 or more people, move range close to cabinet opening. D 2. Remove cardboard or hardboard from under range. Move range into its final location. E 3. Attach the backguard or i
ملخص المحتوى في الصفحة رقم 11
D 4. If your cooktop only has surface burners, see “Check Operation of Surface Burners, Grill and Griddle” section in the Make Gas Connection “Electronic Ignition System” section. 1. Assemble flexible connector from gas supply pipe to pressure 5. If your model was shipped with a grill or griddle, see “Install regulator located in the middle front of the range. Grill” or “Install Griddle” section. 2. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexibl
ملخص المحتوى في الصفحة رقم 12
4. Place burner assembly over spill guard, making sure burner’s rear flange is seated in slot. Install Griddle (on some models) The griddle is factory installed. 1. Place drip tray in the well at the front of the griddle. Slide tray toward the back until it stops. A B 5. Check the surface burner and grill flames. Refer to the “Electronic Ignition System” section. 6. Install the wave tray into the grill. The tab in the left rear corner of the bay must fit through the slot in the left rear co
ملخص المحتوى في الصفحة رقم 13
Electronic Ignition System Initial lighting and gas flame adjustments Adjust Flame Height Surface burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the “LITE” position, Adjust the height of surface burner or grill flames. the system creates a spark to light the burner. This sparking continues, as long as the control knob is turned to “LITE.” NOTE: There is no adjustment for the griddle flame. Gas flow is at 100%, temperature is controlle
ملخص المحتوى في الصفحة رقم 14
Check Operation of Oven Broil Element Complete Installation 1. Check that all parts are now installed. If there is an extra part, 1. Close the oven door. go back through the steps to see which step was skipped. 2. Turn oven selector to BROIL. HI will appear in the 2. Dispose of/recycle all packaging materials. temperature display. 3. Check that range is correctly positioned in countertop cutout 3. Press ENTER. Look through oven window. The top element and that the range is level. See “Level
ملخص المحتوى في الصفحة رقم 15
WIRING DIAGRAMS Cooktop Schematic Cooktop Schematic with Grill Cooktop Schematic with Griddle 15
ملخص المحتوى في الصفحة رقم 16
Oven Schematic *Blower remains off until oven reaches 190°F (88°C) and may continue running up to 45 minutes after oven has turned off. NOTE: Circuit is shown in standby/off mode with oven door closed. W10044930B 12/06 © 2006. All rights reserved. ® Registered Trademark/TM Trademark of KitchenAid, U.S.A. Printed in U.S.A.
