Audiovox IM-100 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

..
5. Pre-wire radio. Slide radio into din sleeve until it
DIN MOUNTING (EXAMPLE:VOLKSWAGON)
locks into place. Note: Use either rear bushing
SEE FIG. 1
or perforated strap to secure rear of radio.
1. Verify opening is within following dimensions:
A. Height 52mm- 53mm (23/64" -23/32")
RADIO REMOVAL (IF NECESSARY)
B. Width 182mm -184mm (75/32" -71/4")
1. Unsnap trimring on face of radio.
2. If opening is less, carefull file to exact size
2. Insert removal tool in slotted holes on sides of
required

ملخص المحتوى في الصفحة رقم 2

screws included with radio (see fig. 2) FACTORY STYLE INSTALLATION CAUTION: Do not use longer screws or (EXAMPLE:TOYOTA) SEE FIG.2: damage to Internal parts of radio may occur 1. Remove factory radio dash panel to expose 5. Re-Install radio / bracket assembly after wiring sub-dash. 2. Remove radio bracket assembly from sub-dash. radio. 6. Replace dash panel. 3. Remove and discard radio dummy panel attached to factory radio bracket assembly. RADIO REMOVAL (IF NECESSARY) 4. Install radio Into brac