ملخص المحتوى في الصفحة رقم 1
®
ViewSonic
PJ766D
DLP Projector
- User Guide
- Guide de l'utilisateur
- Bedienungsanleitung
- Guía del usuario
- 使用手冊
- 使用手冊
Model No. : VS11200
i
ملخص المحتوى في الصفحة رقم 2
Compliance Information For U.S.A. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) The device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
ملخص المحتوى في الصفحة رقم 3
Important Safety Information Congratulations on purchasing the DLP projector! Important: It is strongly recommended that you read this section carefully before using the projector. These safety and usage instructions will ensure that you enjoy many years safe use of the projector. Keep this manual for future reference. Symbols Used Warning symbols are used on the unit and in this manual to alert you of hazardous situations. The following boxes are used in this manual to alert you to
ملخص المحتوى في الصفحة رقم 4
General Safety Information Do not open the unit case. Aside from the projection lamp, there are no user-serviceable parts in the unit. For servicing, contact qualified service personnel. Follow all warnings and cautions in this manual and on the unit case. The projection lamp is extremely bright by design. To avoid damage to eyes, do not look into the lens when the lamp is on. Do not place the unit on an unstable surface, cart, or stand. Avoid using the system near water, in direct
ملخص المحتوى في الصفحة رقم 5
Copyright Information ® Copyright © ViewSonic Corporation, 2006. All rights reserved. Macintosh and Power Macintosh are registered trademarks of Apple Computer, Inc. Microsoft, Windows, Windows NT, and the Windows logo are registered trademarks of Microsoft Corporation in the United States and other countries. ViewSonic, the three birds logo, OnView, ViewMatch, and ViewMeter are registered trademarks of ViewSonic Corporation. VESA is a registered trademark of the Video Electronics Standar
ملخص المحتوى في الصفحة رقم 6
Table of contents GETTING STARTED .......................................................................................................................................................... 1 PACKING CHECKLIST........................................................................................................................................................... 1 VIEWS OF PROJECTOR PARTS...........................................................................................................
ملخص المحتوى في الصفحة رقم 7
GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included: DLP PROJECTOR WITH LENS CAP REMOTE CONTROL (WITH TWO AAA BATTERIES) 250V POWER CABLE USB CABLE S-VIDEO CABLE COMPUTER CABLE (DVI- DB15) CD-ROM (THIS USER’S MANUAL) MULTI-LANGUAGE QUICK START GUIDE CARRYING CASE Contact your dealer immediately if any items are missing, appear damaged, or if the unit does not work. Caution: 1. Avoid using the projector
ملخص المحتوى في الصفحة رقم 8
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Views of Projector Parts Front-left view 3 1 2 8 5 7 6 4 ITEM LABEL DESCRIPTION SEE PAGE: 1. Zoom Enlarges the projected image 15 2. See OSD buttons and LEDs below 3 3. Projection lamp cover Remove when changing lamp 29 4. IR receiver Receiver for IR signal from remote control 8 5. Lens/focus Remove cover, turn the lens to focus 15 6. Height adj
ملخص المحتوى في الصفحة رقم 9
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Top view—OSD buttons and LEDs 12 3 4 READY POWER 5 KEYSTONE POWER 6 SOURCE 7 VOL - VOL + AUTO 8 MENU 9 11 10 ITEM LABEL DESCRIPTION SEE PAGE: 1. Volume/ Decreases volume 16,17 left cursor Navigates and changes settings in the OSD Keystone/ Corrects image-trapezoid (narrower top) effect 15, 17 Up cursor Navigates and changes settings in the OSD Orange Lamp re
ملخص المحتوى في الصفحة رقم 10
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts ITEM LABEL DESCRIPTION SEE PAGE: 7. Auto Optimizes image size, position, and resolution 17 8. Menu Opens/exits the On-Screen Display (OSD) 9. Enter Changes settings in the OSD 10. Keystone/ Corrects image-trapezoid (narrower bottom) effect 15, 17 Down cursor Navigates and changes settings in the OSD ViewSonic PJ766D 4
ملخص المحتوى في الصفحة رقم 11
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Rear view—connectors 12 34 56 7 18 17 1615 14 13 12 11 10 9 8 ITEM LABEL DESCRIPTION SEE PAGE: DVI-I Connect the DVI cable (supplied) from a computer 1. RGB IN Connect a VGA cable (not supplied) from a computer 2. RGB OUT Connect to a monitor 3. RS-232 Installation control and firmware upgrades 4. 12 USB Connect the USB cable (supplied) from a computer 5.
ملخص المحتوى في الصفحة رقم 12
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts ITEM LABEL DESCRIPTION SEE PAGE: Kensington Lock Secure to permanent object with a Kensington Lock system 32 15. Pr/Cr 16. Component Pb/Cb Connect a component video enabled device 12 17. video in Y 18. Note: If your video equipment has both S-video and RCA jacks (composite video) connect to the S-video connector. S-video provides a better quality signal
ملخص المحتوى في الصفحة رقم 13
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Bottom view 11 2 3 3 3 2 ITEM LABEL DESCRIPTION SEE PAGE: Height adjuster buttons Push to release height adjusters 1. 14 Height adjusters Adjusters drop down when adjuster buttons 2. are pushed Ceiling support holes Contact your dealer for information on mounting the projector on a 3. ceiling. ViewSonic PJ766D 7
ملخص المحتوى في الصفحة رقم 14
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Remote Control Parts 28 1 2 27 3 4 26 5 25 6 24 7 8 23 9 22 10 21 11 20 19 12 18 13 17 14 16 15 Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequency fluo- rescent lights can disrupt remote control operation. 2. Be sure nothing obstructs the path between the remote control and the projector. If the path be- tween
ملخص المحتوى في الصفحة رقم 15
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts ITEM LABEL DESCRIPTION SEE PAGE: Up Up arrow when connected through USB to a PC 4. Right Right arrow when connected through USB to a PC 5. Down Down arrow when connected through USB to a PC 6. Page Down Page down when connected through USB to a PC 7. Up cursor 8. Right cursor Navigates and changes settings in the OSD 17 9. Down cursor 10. Volume +
ملخص المحتوى في الصفحة رقم 16
Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Getting Started—Views of Projector Parts Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necessary to point the remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the projector, the remote functions within a radius of about (7) meters (23 feet) and 30 de- grees above or below the p
ملخص المحتوى في الصفحة رقم 17
Setup and Operation Setup and Operation Setup and Operation SETUP AND OPERATION Inserting the Remote Control Batteries Remove the battery compartment cover 1. by sliding the cover in the direction of the arrow. Insert the supplied batteries taking note 2. of the polarity (+/-) as shown here. Replace the cover. 3. Caution: 1. Only use AAA alkaline batteries. 2. Dispose of used batteries according to local ordinance regulations. 3. Remove the batteries when not using
ملخص المحتوى في الصفحة رقم 18
Setup and Operation Setup and Operation Setup and Operation Connecting Input Devices A PC or notebook computer as well as video devices can be connected to the projector at the same time. Video devices include DVD, VCD, and VHS players, as well as movie camcorders and digital still cameras. Check the user manual of the connecting device to confirm it has the appropriate output connector. B C D E F A DVI-I IN RS-232C RGB IN RGB OUT USB AUDIO-IN Y P/BS C P/RR C S-VIDEO IN VIDEO IN L-AUD
ملخص المحتوى في الصفحة رقم 19
Setup and Operation Setup and Operation Setup and Operation Starting and Shutting down the Projector Connect the power cord to the projec- 1. tor. Connect the other end to a wall outlet. (A) Turn on the power switch. (B) The Power LED and Lamp-ready LED turn on. Remove the lens cover. 2. Turn on the connected devices. 3. Ensure the Lamp-ready LED is on a 4. steady (not flashing) orange and then press the Power button to turn on the projector. The projector splash scr
ملخص المحتوى في الصفحة رقم 20
Setup and Operation Setup and Operation Setup and Operation Adjusting the Projector Level Take note of the following when setting up the projector: • The projector table or stand should be level and sturdy. • Position the projector so that it is perpendicular to the screen. • Be sure cables are not in the way or can cause the projector to be knocked over. To raise the level of the projector, lift the projector [A] and press the height-adjuster 1. buttons [B]. The height-adjusters
