ملخص المحتوى في الصفحة رقم 1
English
Table of Contents
-- Usage Notice
------- Precautions ........................................................................................... 2
Introduction
------- Product Features ................................................................................... 3
------- Package Overview ................................................................................. 4
------- Product Overview ................................................................................... 5
ملخص المحتوى في الصفحة رقم 2
English Usage Notice Warning- Do not look into the lens. The bright light may hurt your eyes. Warning- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. Warning- Please do not open or disassemble the product as this may cause electric shock. Warning- When changing the lamp, please allow unit to cool down, and follow all changing instructions. Warning- This product will detect the life of the lamp itself. Please be sure to change the lamp when it show
ملخص المحتوى في الصفحة رقم 3
English Introduction Product Features TM This product is an SVGA single chip 0.7” DLP projector. The outstanding features of it are listed as follows: True SVGA, 800 x 600 addressable pixels 6.4 lbs (2.9 kgs) compact design TM Single chip DLP technology XGA compression and VGA, SVGA re-sizing 200 Watts user replaceable UHP lamp Mac compatible NTSC/NTSC4.43/PAL/PAL-M/PAL-N/SECAM and HDTV compatible Full function remote with mouse control and laser pointer High-tech DVI Connectio
ملخص المحتوى في الصفحة رقم 4
English Introduction Package Overview This projector comes with all the items shown below. Check to make sure your unit is complete. Contact your dealer immediately if anything is missing. 2 1 Projector with lens cap Power Cord VGA Cable 3 4 5 S-Video Cable Audio Cable Jack/RCA Composite Video Cable 6 7 Remote Control with Mouse DVI to D-Sub Cable Function and Laser Pointer Remote Mouse Y Cable User’s Guide Quick Start Card Warranty Card Carrying Case Battery x 2 4
ملخص المحتوى في الصفحة رقم 5
English Introduction Product Overview Main Unit 7 1 2 6 3 5 4 8 9 10 1. Panel Control 2. Power Connector & Power Switch 3. Connection Ports 4. Focus Ring 5. Zoom Lens 6. Zoom Ring 7. Speaker 8. Remote Control Receiver 9. Elevator Button 10. Elevator Foot 5
ملخص المحتوى في الصفحة رقم 6
English Introduction Panel Control 2 6 1 8 3 9 4 10 11 5 7 1. Lamp Warning LED 2. Temperature Warning LED 3. Volume 4. Mute 5. Menu (On/Off) 6. Four Directional Select Keys 7. Enter 8. Zoom 9. Re-sync 10. Source 11. Power /Standby Connection Ports 5 7 9 12 1 2 3 4 6 10 11 13 8 1 RS232 Input Connector (RS232 is for after service purpose only) 2. Audio Input for Video 3. Composite Video Input Connector 4. S-Video Input Connector 5. Audio Input for DVI 6. DVI Input Connecter 7. Audio Input for
ملخص المحتوى في الصفحة رقم 7
English Introduction Remote Control with Mouse Function & Laser Pointer LED Multi-Directional Selector Power / Standby Re-sync Page Down Source Laser Pointer Page Up Keystone Correction Volume ( + / - ) Zoom In / Zoom Out Mute Menu Freeze Cover Close the cover of the remote control when you want to use the remote mouse. Laser Pointer Caution Enter Key Caution : To reduce the risk of injury to the eyes, do not look directly into the laser light on the remote control and do not point the laser li
ملخص المحتوى في الصفحة رقم 8
English Installation Connecting the Projector Digital Tuner Output Video Output INPUT OUTPUT 4 1 5 MOUSE 3 RS232 6 7 RGB S-Video Output USB 1. Power Cord 2 2. VGA Cable 3. S-Video Cable 4. Audio Cable Jack/RCA 5. Composite Video Cable 6. DVI to D-Sub Cable 7. Remote Mouse Y Cable 8 8. D-Sub to RCA Cable for HDTV/Component (optional) Antenna Digital Tuner Output To ensure the projector works well with your computer, please configure the display mode
ملخص المحتوى في الصفحة رقم 9
English Installation Power On/Off the Projector Powering On the Projector 1. Remove the lens cap. 2. Ensure that the power cord and signal cable are securely connected. 3. Turn on the main power switch on the side of the projector and allow the projector to warm up for 1-2 minutes. 4. Turn on the lamp by pressing “Power/Standby” button on the control panel. The startup screen will display and count down for 20 seconds and the Power/Standby indicator will light solid amber. The “LAMP” LED i
ملخص المحتوى في الصفحة رقم 10
English Installation Powering Off the Projector 1. Press the “Power/Standby” button to turn off the projector lamp. 2. After pressing the “Power/Standby” button, you will see a message “Power off the lamp?” on the on-screen display. Press the “Power/ Standby” button again to confirm. Otherwise the message will disappear after 5 seconds. 3. “Power/Standby” LED indicator will light solid amber for about 30 seconds. After the “Power/Standby” indicator starts flashing, you can turn off the main powe
ملخص المحتوى في الصفحة رقم 11
English Installation Adjusting the Projected Image Adjusting the Projector Height The projector is equipped with an elevator foot for adjusting the projector height. To raise the projector: 1. Press the elevator button . 2. Raise the projector to the desired display angle , then release the button to lock the elevator foot into position. 3. Use to fine-tune height adjustment. To lower the projector: 1. Press the elevator button. 2. Lower down the projector, then release the button to lock th
ملخص المحتوى في الصفحة رقم 12
English Installation Adjusting the Projector Zoom / Focus You may adjust zoom ring to zoom in / out. Rotate the zoom ring counter- clockwise to zoom in and clockwise to zoom out. To focus the image, rotate the focus ring until the image is clear. The projector will focus at distances from 3.7 feet to 40.7 feet (1.1m to 12.4m). Zoom Ring Focus Ring Adjusting Projection Image Size Screen Max. 28" 98" 123" 197" 246" 305" (Diagonal)M" in. 2" 2 7" 8 9" 8 1" 57 1" 97 244 Max.(WxH) 22.4" x 16.8" 78.4
ملخص المحتوى في الصفحة رقم 13
English User Controls Panel Control & Remote Control There are two ways for you to control the functions: Remote Control and Panel Control. Panel Control Remote Control Power / Standby Refer to the “Power On/Off the Projector” section on page 9~10. Source Press “Source” to choose RGB, DVI-Digital, DVI-Analog, S-Video, Composite, Component and HDTV sources. Zoom Use the Panel Control When you press “Zoom” button, the zoom icon appears in the screen. Press or button to zoom in or zoom out
ملخص المحتوى في الصفحة رقم 14
English User Controls Four Directional Select Keys When you close the cover of remote control, this key can be used as a mouse to control direction. The above function is only enabled with the connection between computer Page Up / Page Down : Under and projector by remote mouse Y cable. remote mouse connected status only. When the cover of remote control is opened, this key can be used for the operation for OSD display. Page Up (Computer mode only) Use this button to page up. Pag
ملخص المحتوى في الصفحة رقم 15
English User Controls On-Screen Display Menus How to operate The Projector has multilingual On-Screen Display(OSD) menus that allow you to make image adjustments and change a variety of settings. In computer source, the OSD will be the “Computer OSD”. In video source, the OSD will be the “ Video OSD”. The projector will detect the source automatically. To open the OSD menu, press the “Menu” button on the Remote Control or Panel Control. When OSD is displayed, press key to select menu ite
ملخص المحتوى في الصفحة رقم 16
English User Controls Computer mode Language Management Image-I Image-II Audio Brightness Zoom Contrast Keystone Color Temp. Image-I (Computer mode) Brightness Adjusting the brightness of the image. Press the to darken the image. Press the to lighten the image. Contrast The contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting the contrast changes the amount of black and white in the image. Press the to decrease the contrast.
ملخص المحتوى في الصفحة رقم 17
English User Controls Video mode Language Management Image-I Image-II Audio Brightness Tint Contrast Sharpness Color Image-I (Video mode) Brightness Adjusting the brightness of the image. Press the to darken the image. Press the to lighten the image. Contrast The contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting the contrast changes the amount of black and white in the image. Press the to decrease the contrast. Press the
ملخص المحتوى في الصفحة رقم 18
English User Controls Computer mode Language Management Image-I Image-II Audio Frequency H. Position Tracking V. Position 16:9 / 4:3 Reset Image-II (Computer mode) Yes No Frequency “Frequency” is for changing the display data frequency to match the frequency of your computer’s graphic card. When you experience a vertical flickering bar, use this function to make an adjustment. Tracking Choose “Tracking” item to synchronize the signal timing of the display with that of the graphic card. When you
ملخص المحتوى في الصفحة رقم 19
English User Controls Video mode Language Management Image-I Image-II Audio Keystone Color Temp. 16:9 / 4:3 Reset Yes No Image-II (Video mode) Keystone Correction Adjust image distortion caused by tilting the projector. (±16 degrees) 16 : 9 / 4 : 3 You can use this function to fit your desired aspect ratio type. Color Temperature Adjust the color temperature. The range is from 6000K to 9000K . The factory default is 7500K. With the higher temperature, the screen looks colder; with the lowe
ملخص المحتوى في الصفحة رقم 20
English User Controls Computer / Video mode Language Management Image-I Image-II Audio Volume Stereo / Mono Treble Mute Bass Audio Volume Press the to decrease the volume. Press the to increase the volume. Treble The treble setting controls the higher frequencies of your audio source. Press the to decrease the treble. Press the to increase the treble. Bass The Bass setting controls the lower frequencies of your audio source. Press the to decrease the bass. Press the t
