Knoll Systems UDR-HDMI دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Connecting Infrared: Infrared receivers and emitters can be
UDR-HDMI Receiver
connected on either side. Please note 12 volt power for the infrared is
UDS-HDMI Sender
supplied only on the HDMI send or HDMI receive that has the PS1205
UR-HDMI Receiver
power supply connected. Emitters should be connected using a Knoll
US-HDMI Sender
infrared connection block (IR55) or using an inline (series) 220 ohm
dropping resistor to avoid early emitter failure.

Installation Instructions v1.7

ملخص المحتوى في الصفحة رقم 2

Power requirements: The Knoll HDMI balun system requires a single PS1205 power supply connected to the send or receive unit. Wiring: A send module (UDS-HDMI Note: If the cat 5 wire length exceeds 70’ (21m) we strongly or US-HDMI) needs suggest connecting the power supply to the receive side only. to be connected to a Knoll receive module (UDR-HDMI or UR- Note: The HDMI decora style and enclosure style HDMI) to work Models can be mixed or matched as desired. correctly. T