ملخص المحتوى في الصفحة رقم 1
Read this Quick Setup Guide before using the printer.
Before you can use the printer, you must set up the hardware and install
the driver.
Step 1
Setting Up Your Printer
Step 2
Installing the Driver
USB Parallel USB
® ®
page 12 page 14
Mac Mac
(Not available
OS 8.6 – 9.2 OS X 10.1 –
on HL-5030)
10.2
page 20
HL-5030 HL-5050
HL-5040 page 17
page 16
Setup is Complete!
For the latest driver and to find the best solution for your problem or question, access the Brother
Solutions Center directly
ملخص المحتوى في الصفحة رقم 2
Safety Precautions To Use the Printer Safely Warning Note Hint User's Guide Indicates warnings that Indicates cautions that Indicates notes and Indicates reference to the must be observed to must be observed to use useful tips to remember User's Guide which is on prevent possible the printer properly or when using the printer. the CD-ROM we have personal injury. prevent damage to the supplied. printer. Warning There are high voltage electrodes inside the printer. Before replacing internal p
ملخص المحتوى في الصفحة رقم 3
Table of Contents Regulations ........................................................................................................... 2 ■ Getting Started Carton Components ............................................................................................. 4 Control Panel ........................................................................................................ 5 Supplied CD-ROM ...........................................................................................
ملخص المحتوى في الصفحة رقم 4
Regulations Federal Communications Commission (FCC) Declaration of Conformity (For USA) Responsible Party: Brother International Corporation "EC" Declaration of Conformity 100 Somerset Corporate Boulevard P.O. Box 6911 Manufacture Bridgewater, NJ 08807-0911 Brother Industries Ltd., USA 15-1, Naeshiro-cho, Mizuho-ku, Telephone: (908) 704-1700 Nagoya 467-8561, Japan declares, that the products Plant Brother Corporation (Asia) Ltd., Product name: Laser Printer HL-5030, 5040, 5050 and HL-5070N Br
ملخص المحتوى في الصفحة رقم 5
FDA Regulations (100 to 120 volt Model Only) Caution for batteries Do not replace the battery. There is a danger of explosion if the battery is U.S. Food and Drug Administration (FDA) has implemented regulations for incorrectly replaced. Do not disassemble, recharge or dispose of the battery laser products manufactured on and after August 2, 1976. Compliance is in fire. Dispose of used batteries according to local regulations. mandatory for products marketed in the United States. One of the
ملخص المحتوى في الصفحة رقم 6
■ Getting Started Carton Components Printer 1 7 2 1 Face-down Output Tray Support Flap (Support Flap) 2 Control Panel 3 3 Front Cover Release Button 4 Manual Feed Tray (HL-5030/5040) 4 Multi-purpose Tray (HL-5050) 5 Paper Tray 6 Front Cover 7 Face-down Output Tray (Top Output Tray) 5 6 CD-ROM Quick Setup Guide Drum Unit Assembly AC Power Cord (including User's Guide) (including Toner Cartridge) Carton components may differ from one country to another. Save all packing materials and the printer
ملخص المحتوى في الصفحة رقم 7
Control Panel 1 Toner LED indicates when the Toner is low or empty. 1 LED indicates when the Drum is nearing end 2Drum 2 of life. 3 LED indicates when there is a paper jam. 3 Paper The LED will flash and change color 4 Status depending on the printer status. 4 5 Job Cancel Button Will stop and cancel the print operation in progress. 6 Go Button 5 Pause / Continue printing. 6 Printer LED Indications : Blinking : ON : OFF Warming Receiving Data Printer LED Sleep / OFF Ready Up Data Remaining To
ملخص المحتوى في الصفحة رقم 8
Supplied CD-ROM You can find a variety of information on the CD-ROM. ® 3 Mac OS 8.6 ® Mac OS X 10.1 to 9.2 Users to 10.2 Users 1 4 5 3 2 4 6 5 7 1 2 6 7 1 Initial Setup Instructional movie for printer setup and driver installation. 2 Install Software Installs the printer driver and utilities. 3 Documentation View the Printer User's Guide and Network User's Guide in PDF format. (Viewer included) 4 Learn More Watch instructional movies to learn more about using your Brother printer. 5 Brother So
ملخص المحتوى في الصفحة رقم 9
Step 1 Setting Up Your Printer 1 Insert the CD-ROM into the CD-ROM Drive ® ® For Windows Users For Macintosh Users Do NOT connect the interface cable. Do NOT connect the interface cable. Connecting the interface cable is Connecting the interface cable is done when installing the driver. done when installing the driver. 1 Insert the CD-ROM into your CD-ROM 1 Insert the CD-ROM into your CD-ROM drive. Double-click the Start Here icon or drive. The opening screen will appear Start Here OS X ic
ملخص المحتوى في الصفحة رقم 10
Step 1 Setting Up Your Printer 2 Install the Drum Unit Assembly 3 Rock it from side to side several times to Do NOT connect the interface cable. distribute the toner evenly inside the Connecting the interface cable is assembly. done when installing the driver. 1 Open the front cover by pressing the front cover release button. Front cover release button 4 Put the drum unit assembly into the printer. Front cover 2 Unpack the drum unit assembly. Remove the protective part. Drum unit assembly
ملخص المحتوى في الصفحة رقم 11
3 Load Paper in the Paper Tray 1 Pull the paper tray completely out of the 3 Fan the stack of paper well to avoid paper printer. jams and misfeeds. 4 Put paper in the paper tray. Check that the paper is flat in the tray and below the maximum paper mark. 2 While pressing the paper guide release lever, slide the adjusters to fit the paper size. Check that the guides are firmly in the slots. Up to here. Paper guide release lever 5 Put the paper tray firmly back in the printer. For Legal size p
ملخص المحتوى في الصفحة رقم 12
Step 1 Setting Up Your Printer 4 Print a Test Page 3 After the printer has finished warming up, Do NOT connect the interface cable. the Status LED stops blinking and stays Connecting the interface cable is green. done when installing the driver. Extend the Support flap. 1 Make sure that the printer power switch is off. Connect the AC power cord to the printer. 4 Press the Go button. The printer prints a test page. Check that the test page has printed correctly. 2 Plug the AC power cord
ملخص المحتوى في الصفحة رقم 13
Step 2 Installing the Driver Follow the instructions on this page for your operating system and interface cable. ® ® The screens for Windows in this Quick Setup Guide are based on Windows XP. ® ® The screens for Mac OS X in this Quick Setup Guide are based on Mac OS X 10.1. For USB Interface Cable Users............................Go to page 12 For Parallel Interface Cable Users.......................Go to page 14 (For HL-5040/5050 Users Only) For USB Interface Cable Users ® ■ Mac OS 8.6 to 9.2 U
ملخص المحتوى في الصفحة رقم 14
Step 2 Installing the Driver For USB Interface Cable Users 1. Installing the Driver and Connecting the Printer to Your PC 3 Select the USB interface. If the Found New Hardware Wizard (HL-5030 users will not see this screen.) appears on your PC, click the Cancel button. 4 Click the Install button. 1 Make sure the USB interface cable is NOT connected to the printer, and then begin installing the driver. If you have already connected the cable, remove it. 5 Click the Next button. Follow the
ملخص المحتوى في الصفحة رقم 15
6 When this screen appears, make sure the 2. Setting Your Printer as the printer power switch is on. Default Printer Connect the USB interface cable to your ® (For Windows 2000/XP Users PC, and then connect it to the printer. Click the Next button. Only) 1 Click Start and then Printers and Faxes. 2 Select the Brother HL-5000 series icon. 3 From the File menu, select Set as Default printer. 7 Click the Finish button. The setup is now complete. ® For Windows 98 / Me users: The Setup is no
ملخص المحتوى في الصفحة رقم 16
Step 2 Installing the Driver For Parallel Interface Cable Users (For HL-5040/5050 Users Only) Connecting the Printer to Your PC and Installing the Driver 1 Click Connect the interface cable & 5 Turn on the printer power switch. Install the driver/utility from the Initial Setup menu. If the Found New Hardware Wizard 2 Select the Parallel interface. appears on your PC, click the Cancel button. 3 Turn off the printer power switch. 6 Click the Next button when the movie finishes. 4 Connect the
ملخص المحتوى في الصفحة رقم 17
7 Click the Install button. 8 Click the Next button. Follow the on-screen instructions. 9 Click the Finish button. The Setup is now complete. 15 Installing the Driver ® Setting Up Windows Your Printer Parallel
ملخص المحتوى في الصفحة رقم 18
Step 2 Installing the Driver For USB Interface Cable Users ® For Mac OS 8.6 to 9.2 Users (HL-5030/5040 Users) Installing the Driver & Connecting the Printer to your Macintosh 1 Click Connect the interface cable & 4 Connect the USB interface cable to your Install the driver/utility from the Initial Macintosh, and then connect it to the Setup menu. printer. Do not connect the USB cable to the keyboard USB Port or a non-powered USB Hub. 2 Follow the on-screen instructions, and restart your Ma
ملخص المحتوى في الصفحة رقم 19
For USB Interface Cable Users ® For Mac OS 8.6 to 9.2 Users (HL-5050 Users) 1. Connecting the Printer to your Macintosh & Installing the Driver 1 Make sure the printer power switch is on. 5 Open the Macintosh HD icon. ® 6 For Mac OS 8.6 to 9.04 Users: Open the Apple Extras folder. Open the Apple LaserWriter Software 2 Connect the USB interface cable to your folder. Macintosh, and then connect it to the ® printer. For Mac OS 9.1 to 9.2 Users: ® Open the Applications (Mac OS 9) folder. Do not c
ملخص المحتوى في الصفحة رقم 20
Step 2 Installing the Driver For USB Interface Cable Users ® For Mac OS 8.6 to 9.2 Users (HL-5050 Users) 8 Select Printer (USB), and then click the OK A Click the Create... button. button. 9 Click the Change... button in the B Enter your printer name (HL-5050 series), TM PostScript Printer Description (PPD) and then click the Save button. file. Select Brother HL-5050 series, and then click the Select button. C Select Quit from the File menu. 0 Click the Change... button in the USB The setup
