ملخص المحتوى في الصفحة رقم 1
®
User's Manual
ملخص المحتوى في الصفحة رقم 2
2 EXTENDED RUN TIME SERIES XRT Series of Battery Packs I. INTRODUCTION...............................................................2 Safety Cautions II. INSTALLATION ................................................................5 Cautions ............................................................................5 Installation Placement .......................................................6 Installation, Step-by-step...................................................7 Storage.............
ملخص المحتوى في الصفحة رقم 3
3 Thank you for purchasing the Minuteman XRT series of external Battery Packs for your MINUTEMAN Uninterruptible Power Supply system. It has been designed and manufactured to provide many years of trouble- free service. The batteries used in the XRT series are sealed, maintenance-free, lead- acid batteries, with the electrolyte completely absorbed in the plates and separator material. For maximum battery life, the battery packs should be kept as cool as practical indoors. Expected average bat
ملخص المحتوى في الصفحة رقم 4
4 RECEIVING INSPECTION Upon receipt of the Battery Pack, check the outer packaging for any external damage that may have been caused by the carrier. After removing your Minuteman XRT Battery Pack from its carton, inspect the unit again for any damage that may have occurred in shipping. Notify the carrier and place of purchase immediately if any damage is found. Warranty claims for damage caused by the carrier will not be honored. PLEASE SAVE THE PACKING MATERIALS! The packing materials in whic
ملخص المحتوى في الصفحة رقم 5
5 CAUTION: AVOID INSTALLING THE BATTERY PACKS IN LOCATIONS WHERE THERE IS WATER OR EXCESSIVE HUMIDITY. CAUTION: DO NOT ALLOW WATER OR ANY FOREIGN OBJECTS TO GET INSIDE THE BATTERY PACK. DO NOT PUT OBJECTS CONTAINING LIQUIDS ON OR NEAR THE UNIT. INSTRUCTIONS IMPORTANTES CONCERNANT LA SÉCURITÉ: CONSERVER CES INSTRUCTIONS. CETTE NOTICE CONTIENT DES INSTRUCTIONS IMPORTANTES CONCERNANT LA SÉCURITÉ. ATTENTION: UNE BATTERIE PEUT PRÉSENTER US RISQUE DE CHOC ÉLECTRIQUE, OU DE BRULURE PAR TRANSFERT D'EN
ملخص المحتوى في الصفحة رقم 6
6 CAUTIONS: It is recommended that you turn the UPS off and disconnect it from the AC wall outlet prior to connecting or disconnecting the battery terminals. If battery packs MUST be changed while the UPS is supplying power to protected equipment, they can ONLY be changed while the AC line is supplying power. DO NOT attempt to replace batteries or battery packs while the UPS is in battery backup mode. Be extremely careful while plugging or unplugging additional battery packs. Insure that the
ملخص المحتوى في الصفحة رقم 7
7 INSTALLATION PLACEMENT: Select the location of the battery pack(s) with care and use the following precautions; 1. Avoid locations near heating devices. 2. Avoid locations near water or excessive humidity. 3. Do not expose the Battery Pack to direct sunlight. 4. Route power cords where they cannot be walked on or damaged. The battery packs and UPS unit must be placed on a level, smooth surface and cannot be stacked more than 4 units high. All battery packs that exceed 80 Lbs. must NOT be stac
ملخص المحتوى في الصفحة رقم 8
8 A suggested layout for stacking multiple battery packs should be determined by the technician performing your installation. Each installation is unique to the job site and should be reviewed and planned PRIOR to moving this heavy equipment. Measuring the equipment and the installation site may be required. Always make sure your floor strength is sufficient to handle extreme weight when installing this heavy equipment. NOTE: Some MINUTEMAN XRT Battery Packs are designed for quick connection
ملخص المحتوى في الصفحة رقم 9
ملخص المحتوى في الصفحة رقم 10
10 installed all of the way into the receptacle. Upon successful connection, verify that the bracket will not allow removal of the connector. For multiple battery pack installation, each battery pack is "daisy chained" in a similar fashion, with the cable from the last battery pack connected to the previous pack. Remove the protective strips only from the battery connectors that you use. NOTE: When the protective strip is removed from the XRT UPS or the XRT Battery Pack cable and daisy-chain b
ملخص المحتوى في الصفحة رقم 11
ملخص المحتوى في الصفحة رقم 12
12 7. Reinstall the cover plates on the back of the UPS if they were removed. 8. The unit is now ready for normal startup procedures as described in the UPS owner's manual. Make sure all switches and breakers on all units installed are placed in the ON position. Failure to have all of the switches in the ON position may render the UPS inoperable or reduce the runtime when multiple battery packs are installed. For multiple battery pack installation, each battery pack is "daisy chained" in a sim
ملخص المحتوى في الصفحة رقم 13
ملخص المحتوى في الصفحة رقم 14
ملخص المحتوى في الصفحة رقم 15
15 4. Include a letter with your name, address, daytime phone number, RMA #, a copy of your original sales receipt, and a brief description of the trouble. 5. Mark the RMA # on the outside of all packages. The factory cannot accept any package without the RMA # marked on the outside. 6. Return the Battery Pack by insured, prepaid carrier to: Minuteman UPS 1455 LeMay Drive Carrollton, TX 75007 RMA # XXXX(INSERT RMA NUMBER HERE) FOR SPECIFICATIONS, REFER TO THE OWNERÆS MANUAL PROVIDED WITH THE UP
ملخص المحتوى في الصفحة رقم 16
ملخص المحتوى في الصفحة رقم 17
