Liebert 6000RT230 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

® ™
Liebert GXT3
Quick Start Guide – 5000-6000VA RT230 Models


The Liebert GXT3 is shipped with the following items:
• Terminal Block Communication terminals
• Compact disc with:
o Liebert MultiLink®
o Configuration program
o User manual (electronic version)
• USB cable, one; 2m (6-1/2 ft.) long
• Rack handles with mounting hardware
• Plastic tower support base, one set
• Plastic Bezel
• Warnings, safety instructions booklet and WEEE recycling sheet (ISO 14001 compliance)

If th

ملخص المحتوى في الصفحة رقم 2

® ™ The Liebert GXT3 5000-6000 VA RT230 models are compatible with IT Power Systems. To configure the unit for operation on the IT Power system, remove the 2 screws securing the cover plate in the lower right hand side on the rear of the unit and disconnect the jumper, then replace the cover and secure with the screws. GXT3-5000RT230 and IT Power System GXT3-6000RT230 Connector (with cover removed) External Battery Liebert GXT3 UPS Cabinet Connector GXT3-5000RT230 for an

ملخص المحتوى في الصفحة رقم 3

® ™ The Liebert GXT3 UPS is ready to be powered. 1. Locate the plastic bezel from the shipping box and attach the bezel to the UPS taking care to align the fastening clips on both ends before inserting them into the holes. 2. If your application requires the use of external battery cabinets for longer back up time requirements, connect the first battery cabinet to the UPS with the cable provided with the battery cabinet. Note: Either connector is acceptable to connect the external batter

ملخص المحتوى في الصفحة رقم 4

Troubleshooting ® ™ The following symptoms indicate the Liebert GXT3 is malfunctioning: • The relative indicators illuminate, indicating the UPS has detected a problem. • An alarm buzzer sounds, alerting the user that the UPS requires attention. In addition to the fault indicator being illuminated, one or more of LED segments of battery level indicator will also be illuminated to provide a diagnostic aid to the user, as shown below The descriptions are listed in the following table