ملخص المحتوى في الصفحة رقم 1
USE & CARE MANUAL
READ AND SAVE THESE INSTRUCTIONS
ELECTRONIC CONTROL
AIR CONDITIONER
P/N 220211A243
ملخص المحتوى في الصفحة رقم 2
ROOM AIR CONDITIONER WARRANTY Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this warranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this warranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer. WARRANTY FRI
ملخص المحتوى في الصفحة رقم 3
Record Your Model and Serial Numbers Product Registration Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Model No. Serial No. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. 2 Warranty Contents 3 Product Registration 3 Normal Sounds NOTE: This Owner’s Guide provides 4 Important Safety Instructions specific
ملخص المحتوى في الصفحة رقم 4
Read all instructions before using this air conditioner. Important Safety For Your Safety Instructions Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Read product labels for flammability and other warnings. The power supply cord with this air conditioner contains a current Prevent Accidents detection device designed to reduce the risk To reduce the risk of fire, electrical shock, or injury to persons when using your air conditio
ملخص المحتوى في الصفحة رقم 5
F Fan Mode EnergySaver Timer Cancel Clock Reset Lock Sleep Light F Fan Mode EnergySaver Timer Cancel CleanAir FollowMe Clock Reset Lock Sleep Light ELECTRONIC CONTROL OPERATING INSTRUCTIONS Air Conditioner Features Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the unit control alone or with the remote. ADJUSTS SETTEMP. TEMPERATURE DISPLAYS
ملخص المحتوى في الصفحة رقم 6
Air Conditioner Features (continued) TO CHANGE TEMPERATURE YOU WILL SEE: SETTING: Note: Tap or hold either up( ) or down( ) button until 72 the desired temperature is seen on the display. This tempera- ture will be automatically maintained anywhere between 62˚F (17˚C) and 86˚F (30˚C). If you want the display to read the DO THIS: actual room temperature. See “To Operate on Fan Only” sec- tion on Page 7. PRESS TO RAISE PRESS TO LOWER TO ADJUST FAN SPEEDS: YOU WILL SEE THE SPEED CHOSEN: 88 LIGH
ملخص المحتوى في الصفحة رقم 7
Air Conditioner Features (continued) TO USE DRY MODE: YOU WILL SEE: LIGHT On 62 DO THIS: PRESS Note: Use this mode when the room is already cool below o o MODE BUTTON 65 F (18 C) but the room is slightly humid. CHOOSE DRY TO USE AUTO COOL: YOU WILL SEE 72 LIGHT On DO THIS: Note: In this mode when the room temperature is reached the compressor will shut off and after a few minutes the fan PRESS will switch to the lowest setting, (if a higher setting has been MODE BUTTON originally s
ملخص المحتوى في الصفحة رقم 8
Air Conditioner Features (continued) TO USE THE ENERGY SAVER YOU WILL SEE: FEATURE: LIGHT On 72 Note: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 DO THIS: minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns PRESS ENERGY back on and cooling stars. SAVER BUTTON TIMER: DELAY STOP / START YOU WILL SEE: TIMER SETTING FEATURE LIGHT On DO THIS: 0.5 8.5 No
ملخص المحتوى في الصفحة رقم 9
F F e Fan Mode Fan Mod EnergySaver EnergySaver Timer Timer Cancel CleanAir Cancel CleanAir Clock F l ow e Clock FollowMe Reset Lock o l M Reset Lock Light Sleep Light Sleep Air Conditioner Features (continued) CHECK FILTER FEATURE: YOU WILL SEE: LIGHT On DO THIS: AFTER CLEANING PRESS CHECK FILTER BUTTON Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation. To reset after c
ملخص المحتوى في الصفحة رقم 10
Air Conditioner Features (continued) FAULT CODES: WARNING CODES: If the display reads “AS” or “ED”, In the fan mode if “LO” or “HI” is displayed, a sensor has failed. Contact your this means the room temperature is outside o o Authorized Frigidaire Service Center. the unit set points of 99 F/37 C (HI) or o o 32 F/0 C (LO). YOU WILL SEE TO TURN UNIT OFF: DO THIS: PRESS ON/ OFF BUTTON 10
ملخص المحتوى في الصفحة رقم 11
Air Conditioner Features (continued) ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with. • The “Cool “ circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time. o o o o • The control will maintain the set temperature withi
ملخص المحتوى في الصفحة رقم 12
Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the Care and Cleaning unit before cleaning to prevent shock or fire hazards. Air Filter Cleaning The air filter should be checked at least once a month to see if cleaning is necessary. Trapped particles in the filter can build up and cause an accumulation of frost on the cooling coils. • Push the vent handle to the Vent Closed position (where applicable). • Open the front panel. • Grasp the filter by the center and
ملخص المحتوى في الصفحة رقم 13
Before calling for service, review this list. It may save you time and expense. This list Avoid Service Checklist includes common occurrences that are not the result of defective workman-ship or materials in this appliance. OCCURRENCE SOLUTION Air conditioner will not operate. Wall plug disconnected. Push plug firmly into wall outlet. Plug Current Device Tripped. Press the RESET button. House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker. Contr
