Aube Technologies Power Base PB1 30-024T دليل المستخدم

ملخص المحتوى في الصفحة رقم 1







   
   



The PB130-024T power base is designed to power a TH13X Series
control module. This low voltage power base can be used to drive a
line voltage load using a relay or connect directly to equipment (such
as a hot water system) using a 24 V signal.
Although the PB130-024T is compatible with most relays, it has been
optimized for use with an Aube relay. Aube offers triac relays (SSR)
such

ملخص المحتوى في الصفحة رقم 2

          
  
  Align the bracket tabs on the control module with the Thank you for choosing Aube’s TH131-R regulator. Located in the lower-right corner of the
   holes located on the power base and secure using the control module, this switch is used to The TH131-R is specially designed to control an electric screw. select the heating cycle based on the floor heating installation, a baseboard or a convector.