American Power Conversion RS 500 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation
2
1
Connect the Battery Placement / Power
In compliance with Department of Transportation (DOT) regulations, the Back-UPS is shipped with the
Avoid placing the Back-UPS in:
internal red battery wire disconnected. The Back-UPS will not operate until the internal red wire is con-
®
® nected to the battery. Once connected, allow the Back-UPS to charge for a full eight hours prior to use.
 Direct sunlight
 Excessive heat
Note: Small sparks may occur during battery connection. This

ملخص المحتوى في الصفحة رقم 2

Troubleshooting Back-UPS Storage Use the tables below to solve minor Back-UPS installation and operation problems. Consult APC On-line Before storing, charge the Back-UPS for at least eight hours. Store the Back-UPS covered and upright in Technical Support or call APC Technical Support for assistance with problems that cannot be resolved using a cool, dry location. During storage, recharge the battery in accordance with the following table: this document: Storage Temperature Recharge Frequenc