American Power Conversion 280 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

,QVWDOODWLRQ
&RQQHFWEDWWHU\ZLUH 3ODFH3RZHU
The UPS is shipped with one battery wire disconnected - in compliance with Department of
1. Place the UPS to avoid:
Transportation (DOT) regulations. The UPS will not operate until you connect the wire to the
• Direct sunlight
battery.
• Excessive heat

• Excessive humidity or contact with liquids
®
Back-UPS Office
Press “in” the two tabs on the UPS bottom. Slide the plastic back off the UPS.
The UPS can be wall mounted

ملخص المحتوى في الصفحة رقم 2

:DOO0RXQWLQJRI836RSWLRQDO APC Back-UPS Office can be mounted vertically or horizontally to a wall surface. Use the template below to position the securing fasteners (not supplied) . Note: Position the On/Off switch to the right for horizontal mounting, to the top for vertical. Vertical Mounting Only Horizontal and Vertical Mounting Horizontal Mounting Only 1. Hold this page against the wall with the appropriate edge parallel to the floor. 2. Use thumbtacks to hold this page in place. M