ملخص المحتوى في الصفحة رقم 1
SST-151_e.book 1 ページ ２００３年２月２４日 月曜日 午後１時３６分
ROLAND SPEAKER SYSTEM
SST-151/251
SSW-351
SSM-151
OWNER’S MANUAL
Thank you, and congratulations on your choice of the SST/SSW/SSM Speaker System.
Before using this unit, carefully read the sections entitled: “USING THE UNIT
SAFELY” (p. 2) and “IMPORTANT NOTES” (p. 3). These sections provide
important information concerning the proper operation of the unit. Additionally,
in order to feel assured that you have gained a good grasp of every fea
ملخص المحتوى في الصفحة رقم 2
SST-151_e.book 2 ページ ２００３年２月２４日 月曜日 午後１時３６分 USING THE UNIT SAFELY The symbol alerts the user to important instructions Used for instructions intended to alert or warnings.The specific meaning of the symbol is the user to the risk of death or severe determined by the design contained within the injury should the unit be used triangle. In the case of the symbol at left, it is used for improperly. general cautions, warnings, or alerts to danger. Used for instruct
ملخص المحتوى في الصفحة رقم 3
SST-151_e.book 3 ページ ２００３年２月２４日 月曜日 午後１時３６分 101a • The unit should be located so that its location or position does not interfere with its proper venti- lation. .......................................................................................................... 104 • Try to prevent cords and cables from becoming entangled. Also, all cords and cables should be placed so they are out of the reach of children. ................................................................
ملخص المحتوى في الصفحة رقم 4
SST-151_e.book 4 ページ ２００３年２月２４日 月曜日 午後１時３６分 Making Connections 1. Before you make connections, make sure that the power of all equipment is turned off. Also make sure that the volume controls on your amplifier and mixer are turned to the minimum position. 2. Use speaker cables to connect the output terminals of the amplifier to the inputs of the speakers. When connecting speakers, pay attention to the polarity (+/-) of the amplifier. The SST/SSW/SSM speakers have a nominal impedance
ملخص المحتوى في الصفحة رقم 5
SST-151_e.book 5 ページ ２００３年２月２４日 月曜日 午後１時３６分 SSW-351 The SSW-351 contains a built-in crossover network. There are several ways in which an additional speaker can be connected to the SSW-351. Since the HIGH FREQ OUTPUT is routed The PARALLEL INPUTS can be used as an 1. 2. through the internal crossover network, output to connect an auxiliary woofer or a signal from which the low range has a full range speaker. A full frequency been cut will be sent to the connected range signal will
ملخص المحتوى في الصفحة رقم 6
SST-151_e.book 6 ページ ２００３年２月２４日 月曜日 午後１時３６分 Setting Up the SSM-151 When used as a stage floor monitor, the SSM-151 can be set at two different floor angles. 55° 35° When setting up monitor speakers, be sure to observe the following points in order to prevent the speakers from falling over (exercise caution particularly when using the 55- degree setup, as the speakers may topple more easily in this orientation than when set up 35 degrees). * Do not sit or plac
ملخص المحتوى في الصفحة رقم 7
SST-151_e.book 7 ページ ２００３年２月２４日 月曜日 午後１時３６分 SST-151 Dimensions Rear Panel Network Circuit Diagram 2.2uF 2.7ohm 0.64mH 18ohm TWEETER 0.64mH FULL RANGE PARALLEL INPUTS 2.2uF WOOFER 407(16 ") 1+ DESIGNED BY ROLAND AUDIO DEVELOPMENT CORP. IN CALIFORNIA, USA 1 - NL4MP 267(10-1/2") SST-251 Rear Panel Dimensions Network Circuit Diagram 3.3uF 4.7ohm 1.3mH TWEETER FULL RANGE PARALLEL INPUTS 2.6mH 572(22-1/2") 10uF WOOFER DESIGNED BY ROLAND AUDIO DEVELOPMENT CORP. IN CALIFORNIA, USA 1+ 1 - NL4MP 432(
ملخص المحتوى في الصفحة رقم 8
SST-151_e.book 8 ページ ２００３年２月２４日 月曜日 午後１時３６分 3*RAD
