ملخص المحتوى في الصفحة رقم 1
H-CMD4004
MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN 4” TFT
DISPLAY AND TV TUNER
Instruction manual
DVD/CD/MP3- 4”
TFT-
ملخص المحتوى في الصفحة رقم 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ...............................................................................................................................................2 Important safeguards .....................................................................
ملخص المحتوى في الصفحة رقم 3
Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. Do not attempt to disassemble the unit. Laser beams from
ملخص المحتوى في الصفحة رقم 4
Accessories Remote control ISO connector RCA cable AV-in cable Mounting parts Instruction manual Consumer information Warranty card Front panel case Receiver 4
ملخص المحتوى في الصفحة رقم 5
Installation/connection First complete the electrical connections, and then check them for correctness. Installation way It is an anti-theft installation way. The chassis wear a metal sliding housing. Please have the wiring connection of the power supply, speakers and antenna as for the requirement of the manual, and then install the metal sliding housing into the car according to the diagram. 5
ملخص المحتوى في الصفحة رقم 6
6
ملخص المحتوى في الصفحة رقم 7
Detachable control panel Detaching the front panel Press REL button to remove the panel. Attaching the control panel 1. Insert the left side of the control panel into the main unit. 2. Press the control panel on to the right side of middle of it until a “click” sound is heard. Caution: DO NOT insert the control panel from the right side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop
ملخص المحتوى في الصفحة رقم 8
Electrical connection Notes: Only speakers with 4 ohms impedance may be used. Ensure that the blue auto antenna cable does not make contact with any ground connection. After connecting the Parking Line, the video on the small monitor of the front panel will be display only after braking the car. Use the clip end of a Ground Line provided by manufacturer to connect the Fixing Screw Bolt, use another end of the Ground Line to connect the negative pole of the power source. Otherwise, the video on s
ملخص المحتوى في الصفحة رقم 9
Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. 3. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the color code table below for speaker and power cable connections. Function Connector A Connector B 1 7 Rear R
ملخص المحتوى في الصفحة رقم 10
Panel controls Front panel 1. RESET (RST) button 2. Infra red sensor 3. VOL knob/SEL button 4. AUX in 5. 4/RDM button 6. 5/-10 button 7. 6/+10 button 10
ملخص المحتوى في الصفحة رقم 11
8. ANG button 9. USB jack 10. REL button 11. A.P. button 12. BND button 13. LEFT(AF)/RIGHT(TA) buttons 14. EJECT (EJ) button 15. MOD button 16. PWR/MU button 17. UP/DN buttons 18. TFT display 19. SD/MMC slot 20. 3/RPT button 21. 2/INT button 22. 1/PLAY/PAUSE button 11
ملخص المحتوى في الصفحة رقم 12
Description of the Unit Chassis Facet After removing the Front Panel Description of the Unit Chassis Facet After Sliding Down the Front Panel 12
ملخص المحتوى في الصفحة رقم 13
Remote controller (RC) 1. EQ button 2. PWR button 3. MODE button 4. MU button 5. SEL button 6. SETUP button 7. +/- buttons 8. STOP button 9. Buttons with digits/AF button/TA button 10. CLK button 11. ANGLE/ST button 12. LOC/SLOW_FWD button 13. INT button 14. ZOOM button 15. AUDIO button 16. A-B button 17. OSD button 18. PROG button 19. P/N/BAND button 20. TILT button 21. MENU button 22. UP/DOWN/RIGHT/LEFT cursor buttons/OK button 23. PREV/NEXT buttons 24. PLAY/PAUSE button 13
ملخص المحتوى في الصفحة رقم 14
25. 10+/PTY button 26. SEARCH button 27. APS button 28. RPT button 29. RDM button 30. TITLE/PBC button 31. SUBTITLE button 32. LOUD button 33. STEP button 14
ملخص المحتوى في الصفحة رقم 15
Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the RC. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring into contact the battery with other
ملخص المحتوى في الصفحة رقم 16
General operation Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press RESET button on the panel to restore the unit to the original factory settings. Power on/off Press PWR/MU button on the panel or PWR button on the RC to turn the unit on. Long press PWR/MU button on the front panel or briefly press PWR button on the RC to turn the unit off. Note: After the unit is off, the volume level and radio current settings will be memori
ملخص المحتوى في الصفحة رقم 17
=> DISC (the type of disc in the unit if there is any) => USB (if the USB device is inserted) => CARD (if the SD/ MMC card is inserted) => AUX => TV. Clock setting 1. Press CLK button on the RC to show the clock on the display. 2. Press and hold CLK button, the hour will change its color. Press +/- buttons on RC or rotate the VOL knob on the panel to adjust the hour. 3. Press briefly SEL button again, the minute will change its color. Press +/- buttons on RC or rotate the VOL knob on the panel t
ملخص المحتوى في الصفحة رقم 18
Digital tuner Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Band selection Press MOD button on the panel or MODE button on the RC to select the TUNER mode. Press P/N/BAND button on the RC or BND button on the panel once or more to select: FM1, FM2, FM3, AM1, AM2. Display will show the wave band, frequency and preset station number if already stored. Manual/automa
ملخص المحتوى في الصفحة رقم 19
Auto memory store function Press and hold for 2 seconds APS button on the RC or A.P. button on the panel to enter auto store mode. The radio will automatically store the 6 strongest available stations to the 6 preset memories of the current band. To stop auto store, press this button again. Mono/Stereo selection Press ANGLE/ST button on the RC to select the sound channel: MONO or STEREO. Local radio station search Press LOC button on the RC shortly to turn the LOCAL function ON or OFF. When the
ملخص المحتوى في الصفحة رقم 20
PTY (Program Type) function 1. Press PTY button on the RC to turn the PTY function on. 2. Rotate VOL knob or press +/- buttons on the RC to select the music type or speech type: NEWS, AFFAIRS, INFO, SPORT, EDUCATE, DRAMA, CULTURE, SCIENCE, VARIED, WEATHER, FINANCE, CHILDREN, SOCIAL, RELIGION, PHONE IN, TRAVEL, LEISURE, DOCUMENT, PTY NONE, POP M, ROCK M, EASY M, LIGHT M, CLASSICS, OTHER M, JAZZ, COUNTRY, NATION M, OLDIES, FOLK M. Note: 1. When PTY is selected the radio starts to search correspond
