ملخص المحتوى في الصفحة رقم 1
LYT2196-001B-M
EN
INSTRUCTIONS
HD MEMORY CAMERA
U
GZ-HM1
Dear Customers
Thank you for purchasing this camcorder.
Before use, please read the safety
information and precautions contained in
pages 2 and 3 to ensure safe use of this
product.
For Future Reference:
Enter the Model No. (located on the
bottom of the camcorder) and Serial No.
(located on the battery pack mount of the
camcorder) below.
Model No.
Serial No.
Read these INSTRUCTIONS to
enjoy your CAMCORDER.
For more details on the
ملخص المحتوى في الصفحة رقم 2
Safety Precautions When the equipment is installed in a cabinet or on CAUTION a shelf, make sure that it has sufficient space on all RISK OF ELECTRIC SHOCK DO NOT OPEN sides to allow for ventilation (10 cm (3-15/16") or more on both sides, on top and at the rear). CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, Do not block the ventilation holes. DO NOT REMOVE COVER (OR BACK). (If the ventilation holes are blocked by a NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INSTRUCTIONS Remember that this camcorder is intended for 1. Read these instructions. private consumer use only. 2. Keep these instructions. Any commercial use without proper permission 3. Heed all warnings. is prohibited. (Even if you record an event such 4. Follow all instructions. as a show, performance or exhibition for personal enjoyment, it is strongly recommended that you 5. Do not use this apparatus near water. obtain permission beforehand.) 6. Clean only with dry c
ملخص المحتوى في الصفحة رقم 4
Easy Start Guide Charge the battery before recording Turn off the camcorder and attach the battery pack. Access lamp Power/charge lamp blinks: Accessing files blinks: Charging goes out: Charging finished Do not remove the AC adapter, the battery pack or the SD card when the access lamp is blinking. The battery pack is not Battery Pack charged at the time of purchase. AC Adapter To AC Outlet (110V to 240V) CAUTION Fire or injury may result if batteries NOT approved by JVC are used. Only use
ملخص المحتوى في الصفحة رقم 5
Select the city closest to Date/Time Setting the area where you use T Open the LCD monitor to the camcorder Q turn on the camcorder Power button LCD monitor Select [ON] if daylight U saving time is observed Select [YES] within R 10 seconds Slide your finger up and down on the sensor. Then touch OK. Set the date and time V Touch sensor: Sets the date and time : Moves the cursor to the right & When the message disappears, press the • OK: Clock starts power button for at least 2 seconds to
ملخص المحتوى في الصفحة رقم 6
Video recording CAUTION Before recording an important scene, it is recommended to conduct a trial recording. Slide the mode switch to select ! (video) mode Q Select recording mode (REC) R The mode changes when you press the button. The auto recording indicator appears. Start recording S Remaining space on the recording media Record-standby Video Quality Press the START/STOP button to start recording, and press it again to stop. Recording EN GETTING STARTED
ملخص المحتوى في الصفحة رقم 7
Playing back Select playback mode (PLAY) Q The mode changes when you press the button. Select the desired file R Index screen Select (Touch OK) F S Playback screen To perform operations such as forward search or reverse search (Z p. 22) To view files on TV (Z p. 24) CAUTION Do not forget to make copies after recording! To copy files onto discs (Z p. 26) • To dub files to a VCR/DVD recorder (Z p. 28) • To edit files on your computer (Z p. 29) • EN GETTING STARTED
ملخص المحتوى في الصفحة رقم 8
Contents GETTING STARTED USING WITH TV Accessories ................................................ 10 Viewing Files on TV .................................... 24 Shoe Adapter ................................................ 10 Connection with TV....................................... 24 Preparing the Remote Control ...................... 11 Playback Operation ...................................... 25 Index ............................................................ 12 Tripod Mounting .........
ملخص المحتوى في الصفحة رقم 9
How to use the Touch Read This First! Sensor Make a backup of important recorded data It is recommended to copy your important After the menu is displayed on the LCD recorded data to a DVD or other recording monitor: media for storage. JVC will not be responsible for any lost data. Make a trial recording Before the actual recording of important data, make a trial recording and play back the recorded data to check that the video and sound have been recorded correctly. Reset the camcorder
ملخص المحتوى في الصفحة رقم 10
GETTING ST ARTED Accessories Shoe Adapter An optional microphone or light can be attached to the shoe adapter. AP-V20U BN-VF815U Slide the shoe cover AC Adapter Battery Pack in the direction of the arrow to reveal the shoe adapter mounting socket. Component Cable AV Cable Mount the accessory shoe adapter. LY37115-001B USB Cable Shoe Adapter Fasten the shoe adapter to the shoe adapter mounting socket by turning the screw in the direction of the arrow. CR2025 RM-V760U Remote Control Lith
ملخص المحتوى في الصفحة رقم 11
START SNAP /STOP SHOT INFO INDEX Preparing the Remote Control A battery is included inside the remote control at the time of purchase. Remove the insulation sheet before use. Beam Effective Area Remote Sensor Effective distance: Max. 4 m (13.16 ft) NOTE The transmitted beam may not be effective or may cause incorrect operation when the remote sensor is directly exposed to sunlight or powerful lighting. To Reinsert the Battery Pull out the battery holder by pressing the lock tab. Lithium Bat
ملخص المحتوى في الصفحة رقم 12
Index NOTE START SNAP Be careful not to cover 2, 3, 5, and C • /STOP SHOT during shooting. The LCD monitor can rotate 270°. • INFO INDEX 1 EN GETTING STARTED
ملخص المحتوى في الصفحة رقم 13
Camcorder Remote Control ! Power Button Q Infrared Beam Transmitting Window # SD Card Slot R START/STOP Button $ OPEN knob (Z p. 18) S ZOOM (T) Button (Zoom in) % Speaker T Left Button & PLAY/REC Button (Z p. 19, 20, 22, 23) U ZOOM (W) Button (Zoom Out) ( SNAPSHOT Button (Z p. 20) V INFO Button ) Touch Sensor W SNAPSHOT Button * OK Button X PLAY/PAUSE/SET Button + MENU Button (Z p. 36) Y Right Button , USB Connector (Z p. 26, 30) Z INDEX Button* - Mode Switch [ !, #] * Each time you press INDEX,
ملخص المحتوى في الصفحة رقم 14
Indications on LCD Monitor During both Video and Still Image During Video Recording Only Recording DEC. 24. 2010 4:55 PM ! Mode Indicator ! Selected Recording Mode Indicator # High Speed Recording Indicator/Time- Lapse Recording Indicator (Z p. 19, 20) : Auto Mode $ Upload Mode Indicator (Z p. 35) @ % Counter 3: Manual Mode # Scene Select Indicator & Export Mode Indicator (Z p. 34) ( Video Quality $ Effect Mode Indicator % White Balance Indicator ) Remaining Time * REC: (Appears during recordi
ملخص المحتوى في الصفحة رقم 15
During Video Playback During Still Image Playback 8 DEC. 24. 2010 4:55 PM DEC. 24. 2010 4:55 PM ! Mode Indicator ! Mode Indicator # High Speed Recording Indicator/Time- # Quick Review Indicator (Z p. 20) Lapse Recording Indicator $ Folder/File Number $ Playlist Playback Indicator (Appears when % Slide Show Playback Indicator playing back a playlist.) & Recording Medium Indicator % Quick Review Indicator (Z p. 19) ( Battery Indicator DIGEST: Digest Playback Indicator ) Date/Time ( Z p. 16) & Vid
ملخص المحتوى في الصفحة رقم 16
Necessary Settings before Use NOTE Charging the Battery Pack You can also use the camcorder with just the • AC adapter. The actual recording time may shorten • 1 Close the LCD monitor to turn off the depending on the recording environment, camcorder. such as when recording scenes with fast moving subject. 2 Attach the battery pack, then connect Please do not pull or bend the AC adapter • the AC adapter. plug and cable. This may damage the AC adapter. Date/Time Setting 1 Open the LCD m
ملخص المحتوى في الصفحة رقم 17
7 Select [ON] if daylight saving time is Language Setting observed. The language on the display can be changed. 1 Open the LCD monitor to turn on the camcorder. 2 Touch MENU. 8 Set the date and time. Change the setting by using the touch 3 Select [DISPLAY SETTINGS]. sensor and select [ &] to set. 4 Select [LANGUAGE]. 9 Select [SAVE]. To reset the setting, select [CANCEL]. Setting the clock to local time when traveling After performing steps 1-4 (Z p. 16) 5 Select the desired language. 5 Selec
ملخص المحتوى في الصفحة رقم 18
Other Settings 3 Close the SD card cover. Using an SD Card The camcorder is programmed to record on the built-in memory when it is shipped from the factory. You can change the recording medium to an SD card. Operations are confirmed on the following • SD cards. - Panasonic To remove an SD card - TOSHIBA Push the SD card once. - SanDisk After the card comes out a little, pull it out. - ATP Video recording: NOTE Class 4 or higher compatible SDHC card Insert and remove the SD card o
ملخص المحتوى في الصفحة رقم 19
RECORDING/PLAYBACK Recording Files Video Recording Slide the mode switch to select Press PLAY/REC to select the ! (video) mode. recording mode. SNAPSHOT Press START/STOP to start recording. Approximate remaining time for recording You can also start/stop recording by selecting [REC] on the LCD monitor. (On-screen recording control) To stop recording NOTE Press START/STOP again. The video recording mode is automatically • selected when you turn off the camcorder To view the last recorde
ملخص المحتوى في الصفحة رقم 20
Recording Files (Continued) Still Image Recording Slide the mode switch to select Press PLAY/REC to select the # (still image) mode. recording mode. Press and hold SNAPSHOT halfway. The ? indicator becomes green when the captured image is focused. To view the last recorded image Press SNAPSHOT fully to take a Select after shooting. A still image. Selecting $ during playback deletes that image. To change the image quality Change the settings in [IMAGE QUALITY]. To change the image si
