Sony TRV30 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Owner’s Manual
For Sony TRV30, TRV730, TRV530, TRV330 and TRV120 Camcorders
www.uwimaging.com

ملخص المحتوى في الصفحة رقم 2

Welcome Table of Contents Congratulations on your purchase of a Stingray II video housing. Please inspect the packaging of your product to verify that there was no Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 damage during shipping. Camera Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 If you are not familiar with your camcorder’s features, please take

ملخص المحتوى في الصفحة رقم 3

Getting Started Camera Preparation 1) Install the appropriate fully charged Sony camcorder battery. 2) Install a Sony MiniDV tape or Digital8 tape into your camcorder. Illustrated below are the locations of Stingray’s features, ports, and 3) Install a Memory Stick in your camcorder functions. Take time to familiarize yourself with the housing. Mounting the Camera 1. Remove the rear plate by simultaneously rotating both latches down and rearward of the housing body. 2. Remove the Camera Tray. A.

ملخص المحتوى في الصفحة رقم 4

12. Slide Camera Tray forward until Release Button engages. Left Control Set 13. Rotate camcorder power switch to Memory. FOCUS Switch N - Slide switch forward and hold to put camcorder into manual focus and $ Although camcorder Power switch is set to Memory, when move focus point closer to camcorder. camcorder initially interfaces with Stingray, it will be in F - Slide switch backward and hold to put camcorder into manual focus and Camera mode. move focus point further from camcorder. MOM. AF

ملخص المحتوى في الصفحة رقم 5

Front Optic Installation / Removal Pre-Dive Checklist 1) Install a Mini DV / Digital 8 tape and Memory Stick in the camcorder. To Remove Optic 2) Install a completely charged battery in the camcorder. 1. Slide LOCKING PIN away from optic. 3) Verify operation of all housing controls. 2. Rotate optic counter clockwise. 4) Check that the front bayonet port is securely engaged and that the latch pin 3. Pull away from housing. is in the locked position. Clean lens if necessary. 5) Check that the rear

ملخص المحتوى في الصفحة رقم 6

O-ring Care & Maintenance Returning Products for Care O-rings are the critical component that keeps water out of the housing. We highly recommend a factory annual service to Routinely inspect o-rings and replace at least once a year. If your o-rings maintain proper operation of your Stingray II Housing are damaged, contact the Light & Motion service department for an o- ring replacement kit. 1) Before returning your Light & Motion product for care, please call or email our service department fo

ملخص المحتوى في الصفحة رقم 7

300 Cannery Row • Monterey, CA 93940 (831) 645-1525 • Fax (831) 375-2517 www.uwimaging.com