ملخص المحتوى في الصفحة رقم 1
Installation
7420
Instructions
PORTSMOUTH™ 7420.801
Spread Lavatory Faucet
7420.821
with Speed Connect™ Drain
Series
Congratulations on purchasing your
American Standard faucet with
7415.801
Speed Connect drain, a feature found
onlyon American Standard faucets.
7415.821
Speed Connect Drain*
7415
Series
• Fewer parts, installs in less time
• Never needs adjustment
Certified to comply with ANSI A112.18.1
• Guaranteed to seal properly the first time, every time.
M965015 REV.1.7
*Your new Ameri
ملخص المحتوى في الصفحة رقم 2
POP-UP DRAIN 2 Fig. A. Fig. B. Remove CLEAR PLASTIC COVER (1). 1 Remove CARDBOARD SPACER (2) from under DRAIN DRAIN POP-UP (3). 3 BODY Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B. 2 4 REMOVE FLANGE 3 Fig. A. Fig. B. 1 Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. Fig. A. Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B. 4 2 3 INSTALL DRAIN FROM TIGHTEN LOCKNUT REAR
ملخص المحتوى في الصفحة رقم 3
ATTACH CABLE CONNECTOR 7 Fig. A. Fig. B. Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and 1 hand tighten. Fig. A. Your new POP-UP DRAIN installation is now complete. Fig. B. Note: Tailpeice on pop-up drain is 1-1/4” O.D. Fig. B. 2 1-1/4” O.D. CHECK OPERATION OF POP-UP 8 Operate LIFT KNOB (1) to verify that STOPPER (2) opens and 1 closes. Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions. 2 MAKE WATER SUP
ملخص المحتوى في الصفحة رقم 4
INSTALL HANDLES 10 Push ADAPTER (1) on VALVE STEM (2), so that the hole of the ADAPTER (1) with the spline is facing up. Fig. A. Tighten THREAD ON STEM SCREW (3) to secure ADAPTER (1). TO DECK 4 ADAPTER Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting male teeth on ADAPTER (1) to female teeth in HANDLE (4). SPLINE END UP Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5) 1 until snug against mounting surface. 3 Fig. A. 2 BOTTOM 5 TEST INSTALLED FITTING 11 5 1 With HANDLES (1)
ملخص المحتوى في الصفحة رقم 5
Speed Connect™ Drain Troubleshooting Guide If sink does not hold water even though Stopper is in the “down” position: • Follow CABLE ADJUSTMENT PROCEDURE. If Stopper does not raise up fully or sink drains too slowly: • Follow CABLE ADJUSTMENT PROCEDURE. If you need to remove the Stopper: • Follow STOPPER REMOVAL PROCEDURE. If you would like the ability to remove your Stopper simply by lifting it out of the drain: • Follow STOPPER INSTALLATION PROCEDURE for “Unlocked” mode. C
ملخص المحتوى في الصفحة رقم 6
STOPPER INSTALLATION PROCEDURE The Stopper can be installed two ways, “Locked” Mode (Stopper cannot be removed) or “Unlock” Mode (Stopper is removable). Locked Mode: Look at the Plastic Loop at the bottom of the Stopper and notice Fig. G. that the Loop is on one side of the Stopper. Fig. G. LOGO To install the stopper in “Locked” mode, insert the Stopper into the Drain so that the Plastic Loop is facing toward the rear of the Sink and the American Standard logo is facing front. Rotate Stopper s
ملخص المحتوى في الصفحة رقم 7
PORTSMOUTH™ Spread Lavatory Faucet with Speed Connect™ Drain MODEL NUMBER 7420.801 7420.821 Series M950211-YYY0A LIFT ROD & KNOB M962946-YYY0A CROSS HANDLE M962590-YYY0A SPOUT KIT M962937-YYY0A M922881-YYY0A HANDLE AERATOR Replace the "YYY" with appropriate finish code CHROME 002 BLACKENED BRONZE 068 M911741-0070A OIL RUBBED BRONZE 224 SEAL M962592-0070A SATIN NICKEL 295 DECK ADAPTER KIT M961733-0070A SPOUT MTG. KIT 918555-0070A HANDLE SCREW 918049-0070A ADAPTER M962544-YYY0A 994053-0070A STOPP
ملخص المحتوى في الصفحة رقم 8
PORTSMOUTH™ Spread Lavatory Faucet with Speed Connect™ Drain MODEL NUMBER 7415.801 M962455-YYY0A M962946-YYY0A LIFT ROD & KNOB 7415.821 CROSS HANDLE Series M962052-YYY0A SPOUT KIT M962947-YYY0A HANDLE M922881-YYY0A AERATOR Replace the "YYY" with appropriate finish code M962453-YYY0A CHROME 002 SEAL & ESCUTCHEON BLACKENED BRONZE 068 M962592-0070A DECK ADAPTER KIT OIL RUBBED BRONZE 224 SATIN NICKEL 295 M961733-0070A SPOUT MTG. KIT 918555-0070A HANDLE SCREW 918049-0070A ADAPTER 994053-0070A CARTRI
