ملخص المحتوى في الصفحة رقم 1
DSR-PD100A/PD100AP
3-867-703-13 (1)
Digital
Camcorder
Operating Instructions
Before operating the unit, please read this manual thoroughly,
and retain it for future reference.
Owner’s Record
The model and serial numbers are located on the bottom. Record
the serial number in the space provided below. Refer to these
numbers whenever you call upon your Sony dealer regarding this
product.
Model No. DSR- Model No. AC-
Serial No. Serial No.
TM
SERIES
DSR-PD100A/PD100AP
©1999 Sony Corporation
ملخص المحتوى في الصفحة رقم 2
For the Customers in the U.S.A. WARNING CAUTION To prevent fire or shock hazard, do You are cautioned that any changes or modifications not expressly approved in this manual could void your not expose the unit to rain or authority to operate this equipment. moisture. Declaration of Conformity Trade Name: SONY CAUTION Model No.: DSR-PD100A RISK OF ELECTRIC SHOCK Responsible Party: Sony Electronics Inc. DO NOT OPEN Address: 1 Sony Drive, Park Ridge, NJ, 07656 USA Telephone No.: 201-930-6970 CAUTIO
ملخص المحتوى في الصفحة رقم 3
Before you begin PC card adaptor and “Memory For the Customers in Europe (DSR- Stick” PD100AP) This product with the CE marking complies with both the EMC Directive (89/336/EEC) and Low Voltage Directive (73/23/EEC) issued by the Commission of the N50 European Community. Compliance with these directives implies conformity to the following European standards: • EN60065:Product Safety (supplied AC Adaptor only) For the Customers in CANADA • EN55103-1:Electromagnetic Interference (Emission) This Cl
ملخص المحتوى في الصفحة رقم 4
Table of contents Before you begin Searching the boundaries of recorded Using this manual .............................................. 5 tape with date – date search ................... 75 Checking supplied accessories ........................ 7 Searching the boundaries of recorded tape with title – title search ..................... 77 Getting started Searching for a photo Installing and charging the battery pack ....... 8 – photo search/photo scan ...................... 78 Inserting a casse
ملخص المحتوى في الصفحة رقم 5
Before you begin Before you begin Using this manual The instructions in this manual are for the two models listed below. Before you start reading this manual and operating the unit, check your model number by looking at the bottom of your camcorder. The DSR-PD100A is the model used for illustration purposes. Otherwise, the model name is indicated in the illustrations. Any differences in operation are clearly indicated in the text, for example, “DSR-PD100A only.” As you read through this manual,
ملخص المحتوى في الصفحة رقم 6
Using this manual Precautions on camcorder care •The LCD screen and/or the color viewfinder are manufactured using high-precision technology. However, there may be some tiny black points and/or bright points (red, blue or green in color) that constantly appear on the LCD screen and/or in the viewfinder. These points are normal in the manufacturing process and do not affect the recorded picture in any way. Over 99.99% are operational for effective use. • Do not let the camcorder get wet. Keep the
ملخص المحتوى في الصفحة رقم 7
Before you begin Checking supplied accessories Check that the following accessories are supplied with your camcorder. 1 2 3 4 7 5 6 8 9 0 !Á !ª !£ !¢ 1 Wireless Remote Commander (1) (p. 142) 8 Pouch for XLR adaptor (1) When not using the XLR adaptor, put the 2 AC-L10A AC power adaptor (1), adaptor into the pouch. Power cord (mains lead) (1) (p. 9, 27) The shape of the plug varies from region to 9 A/V connecting cable (1) (p. 72, 82) region. 0 Shoulder strap (1) (p. 143) 3 NP-F330 battery pack (1
ملخص المحتوى في الصفحة رقم 8
Getting started Installing and charging the battery pack Before using your camcorder, you first need to install and charge the battery pack. To charge the battery pack, use the supplied AC power adaptor. This camcorder operates only with the “InfoLITHIUM” battery pack. “InfoLITHIUM” is a trademark of Sony Corporation. Installing the battery pack (1) Lift up the viewfinder. (2) Insert the battery pack in the direction of the $ mark on the battery pack. Slide the battery pack down until it is loc
ملخص المحتوى في الصفحة رقم 9
Getting started POWER MEMORY VTR CAMERA OFF Installing and charging the battery pack Charging the battery pack Charge the battery pack on a flat surface without vibration. The battery pack is charged a little in the factory. (1) Open the DC IN jack cover and connect the supplied AC power adaptor to the DC IN jack with the plug’s 4 mark up. (2) Connect the power cord to the AC power adaptor. (3) Connect the power cord to a wall outlet. (4) Set the POWER switch to OFF. Remaining battery time is in
ملخص المحتوى في الصفحة رقم 10
Installing and charging the battery pack Charging time Battery pack Charging time * NP-F330 (supplied) 150 (90) NP-F530/NP-F550 210 (150) NP-F730/NP-F750/NP-F730H** 300 (240) NP-F930/NP-F950 390 (330) NP-F960 420 (360) The time required for a normal charge is indicated in parentheses. * Approximate minutes to charge an empty battery pack using the supplied AC power adaptor. (Lower temperatures require a longer charging time.) ** NP-F730H is sold only in the U.S.A. Battery life While using with v
ملخص المحتوى في الصفحة رقم 11
Getting started Installing and charging the battery pack Notes on remaining battery time indication during recording •Remaining battery time is displayed on the LCD screen or in the viewfinder. However, the indication may not be displayed properly, depending on using conditions and circumstances. •When you close the LCD panel or open it, it takes about 1 minute for the correct remaining time to be displayed. To remove the battery pack Lift up the viewfinder. While pressing BATT RELEASE, slide
ملخص المحتوى في الصفحة رقم 12
Inserting a cassette You can use mini DVCAM cassette with logo*. Make sure that the power source is installed. (1) While pressing the small blue button on the EJECT switch, slide it in the direction of the arrow. The cassette compartment automatically opens. (2) Insert a cassette with the window facing out. (3) Close the cassette compartment by pressing the “PUSH” mark on the cassette compartment. * is a trademark. 1 2 3 PUSH To eject the cassette While pressing the small blue button on the E
ملخص المحتوى في الصفحة رقم 13
Basic operations POWER MEMORY VTR CAMERA OFF POWER MEMORY VTR CAMERA OFF POWER POWER MEMORY MEMORY VTR CAMERA VTR CAMERA OFF OFF Basic operations Camera recording Make sure that the power source is installed and a cassette is inserted. Before you record one-time events, you had better make a trial recording to make sure that the camcorder is working correctly. When you use the camcorder for the first time, power on it and reset the date and time to your time before you start recording (p. 120).
ملخص المحتوى في الصفحة رقم 14
Camera recording To focus the viewfinder lens If you cannot see the indicators in the viewfinder clearly, or after someone else has used the camcorder, focus the viewfinder lens. Move the viewfinder lens adjustment lever so that the indicators in the viewfinder come into sharp focus. Note on Standby mode If you leave the camcorder in Standby mode for 5 minutes while the cassette is inserted, the camcorder turns off automatically. This prevents wearing down the battery and wearing out the tape. T
ملخص المحتوى في الصفحة رقم 15
Basic operations Camera recording Attaching the lens hood When the supplied wide conversion lens is not attached to the camcorder, we recommend you to attach the lens hood to record fine pictures, no matter where you shoot. You can also attach the lens cap when using the lens hood. Align the protruding part with the groove on the hood. If the lens hood is not attached properly The four corners of the screen may be eclipsed by the lens hood. If an optional lens or filter is attached When an optio
ملخص المحتوى في الصفحة رقم 16
LCD BRIGHT Camera recording Zooming of more than 12x – digital zoom • If you set the D ZOOM function to ON in the menu system, you can perform zooming of more than 12x performed digitally. It is set to OFF at the factory. •You cannot use the digital zoom when you set PROG. SCAN to ON in the menu system. •The right side [a] of the power zoom indicator shows the digital zooming zone, and the left side [b] shows the optical zooming zone. If you set the D ZOOM function to ON, the [a] zone appear
ملخص المحتوى في الصفحة رقم 17
Basic operations Camera recording Notes on the LCD panel •When closing the LCD panel, turn it vertically until it clicks [a]. •When turning the LCD panel, turn it always vertically; otherwise, the camcorder body may be damaged or the LCD panel may not close properly [b]. •Close the LCD panel completely when not in use. •Do not push nor touch the LCD panel while operating the camcorder. •You may find it difficult to view the LCD screen due to glare when using the camcorder outdoors. [a] [b] Letti
ملخص المحتوى في الصفحة رقم 18
Camera recording Notes on mirror mode •When you turn the LCD panel about 135 degrees to 180 degrees, the camcorder enters mirror mode. •Using the mirror mode, you can record yourself while watching yourself on the LCD screen. •The picture on the LCD screen looks like a mirror-image while recording in mirror mode. The STBY indicator appears as Pr and REC as r. Other indicators appear as mirror- image. Some indicators may not appear in mirror mode. •While recording in mirror mode, you cannot opera
ملخص المحتوى في الصفحة رقم 19
Basic operations Camera recording Self-timer recording You can make a recording with the self-timer. This mode is useful when you want to record yourself. (1) Press (self-timer) to display (self-timer) on the LCD screen or in the viewfinder while the camcorder is in Standby mode. (2) Press START/STOP. Self-timer starts counting down to 10 with a beep sound. In the last two seconds of the countdown, the beep sound gets faster, then recording starts automatically at the time you set. START/STOP
ملخص المحتوى في الصفحة رقم 20
Hints for better shooting For hand-held shots, you will get better results by holding the camcorder according to the following suggestions: •Hold the camcorder firmly and secure it with the grip strap so that you can easily manipulate the controls with your thumb. [a] [a] •Place your elbows against your side. •Place your left hand under the camcorder to support it. •Place your eye against the viewfinder eyecup. •Be sure not to touch the built-in microphone. •Use the LCD panel frame or the viewfi
