Epson R800 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Continuous Ink Supply System
for
EPSON Stylus Photo R800

Installation Instruction


For XM Prefilled Version

With Auto Reset Chips



This Version of the Continuous Ink Flow System comes with Prefilled
Cartridges and Auto Reset Chips. You just need to fill the
Reservoir bottles and print! The whole operation is very easy.
It’s really an effective tool to save your money.

ملخص المحتوى في الصفحة رقم 2

CIS for EPSON Stylus Photo R800 Instruction Thank you for purchasing XM Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed XM Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges. Please take your time installing XM Continuous Ink

ملخص المحتوى في الصفحة رقم 3

Put the CISS on the left side Pull out the small rubber plug Place 6pcs of air filters into of the printer. In the meantime from the air hole as above air holes, the thicker side place all the tubes at correct picture shown. is down into tank. position. 2、Second step: Remove the Cartridge A B

ملخص المحتوى في الصفحة رقم 4

4、Step 4. 1)Remove old cartridges in the printer (Pic A); 2) Insert the CIS cartridges into the cartridge car (Pic B); Make sure the cartridges installed well.(Pic.C) A B C 5、Step 5, Fix Supporting Arm: 1) Tear off the sticker(Pic A); Measure 7.50cm from the edge of the printer, Attach supporting arm on the printer as Picture B show; 2) Tear off the sticker of balance arm (Pic.C); Attach it on the supporting arm (Pic.D); 3

ملخص المحتوى في الصفحة رقم 5

Clip the tube clamp Finished 7、Step Seven: Adjusting the Tube A B C A. Adjust the length of the tube, move the cartridge Carrier B. Make Sure the tube moving with the cartridge Carrier will not collide or block the printer. C keep enough length of the tube to make sure the cartridge can reach the end Right side of the printer A

ملخص المحتوى في الصفحة رقم 6

9、Ninth step: Checking the Printing head Printing Head Normal Printing testing normal，Begin to print Printing Head printing Break Printing Break，C

ملخص المحتوى في الصفحة رقم 7

Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill ink according to the color in short supply. Then put the rubber back. (Please keep the printer and the reservoir at the same horizontal line during the process of refilling ink.) 六、Close the car

ملخص المحتوى في الصفحة رقم 8

2. Avoid exposure to direct sunshine and don’t keep it in high or freezing temperature. 3. Avoid collision and fallen down.