Henkel KEEN K-360-36 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

HENKEL, INC
P.O. BOX 1322
HAMMOND, LA 70404
(985) 345-2171
www.keenovens.com

ملخص المحتوى في الصفحة رقم 2

Henkel, Inc. P.O. Box 1322 * Hammond, Louisiana * 70404 * (985) 345-2171 www.keenovens.com Model K-360-36 Holding Ovens Installation Instructions & Repair Parts List One Year Limited Warranty Henkel, Inc. warrants its products against defects in material and workmanship. Henkel, Inc. will either repair or replace without charge any properly installed product which fails under normal operating conditions within one year from date of installation, provided it is

ملخص المحتوى في الصفحة رقم 3

Safety Precautions Read all instructions completely before attempting to operate this unit. *** SAVE THESE SAFETY INSTRUCTIONS *** To reduce the risk of electrical shock, fire, or personal injury follow the guidelines below: • Before connecting unit to a power source, be sure the voltage supplied is the same as that specified on the name plate of the unit. • Check outlet to ensure proper grounding of the electrical cable. Have a licensed electrician check the A/C power out

ملخص المحتوى في الصفحة رقم 4

Temperature Setting The thermostat is adjustable from 150 °F (37.8 °C) to 550 °F (287.8 °C). Turn thermostat knob to desired temperature by aligning with red line on chrome bezel. Pilot light indicates when power supply is supplied to the heating elements. The thermostat is accurate to ±23 °F (14 °C) a the sensor. Temperature variance is minimal throughout the oven due to the heat exchanging qualities of the Keen shelving system. ***CAUTION: DO NOT USE ON D/C POWER SUPPLY! ***

ملخص المحتوى في الصفحة رقم 5

IF OVEN OVERHEATS If oven fails to cycle on and off and reaches temperatures above 550 °F thermostat is faulty and needs replacing. If oven operates but is off from setting see calibration instructions. Corrective Maintenance CHANGING THE HEATING ELEMENT 1. Disconnect oven from power source. 2. Remove back cover and insulation from rear of unit. 3. Disconnect electrical leads from elements. 4. Remove any materials from bottom shelf and remove shelf from oven 5. Unscrew e