Henkel K-NP دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Henkel, Inc.

P.O. Box 1322

Hammond, LA


70404

(985) 345-2171

www.keenovens.com





- 1 -

ملخص المحتوى في الصفحة رقم 2

Henkel, Inc. P.O. Box 1322 * Hammond, Louisiana * 70404 * (985) 345-2171 www.keenovens.com Model K-NP Holding Ovens Installation Instructions & Repair Parts List One Year Limited Warranty Henkel, Inc. warrants its products against defects in material and workmanship. Henkel, Inc. will either repair or replace without charge any properly installed product which fails under normal operating conditions within one year from date of installation, provided it is return

ملخص المحتوى في الصفحة رقم 3

Recommended Spare Parts When it is critical to have continuous operation of this unit: we suggest having the following spare parts on hand: Heating Element Assembly Thermostat Assembly General Information The model K-NP Keen oven is designed for storing filler material and 12 inch wire spools. The unit has shelves that slide out for easy loading and unloading. Each shelf is fabricated from perforated iron and is capable of holding 50 pounds of material. The lower section of the

ملخص المحتوى في الصفحة رقم 4

• Do not store combustible material on or around the unit. • Do not operate this unit empty. • When using the unit at a distance where an extension cord becomes necessary, a 3-conductor grounding cord of adequate size must be used for safety, and to prevent loss of power and overheating. Use only a UL listed extension cord suitable for outdoor use. Make certain wire size is large enough for A/C amperage rating of unit. Operation Locate oven in an area free of combustible materia

ملخص المحتوى في الصفحة رقم 5

IF OVEN FAILS TO OPERATE – NO HEAT 1. Check power source. 2. Check power cord continuity. Replace cord assembly if faulty. 3. If pilot light glows, voltage is being supplied to heating elements. Check elements continuity. If defective, replace. 4. If thermostat cannot be heard clicking on and off when dial is rotated, and if pilot light fails to operate, replace thermostat. IF OVEN OVERHEATS If oven fails to cycle on and off and reaches temperatures above 250 °F thermostat is f

ملخص المحتوى في الصفحة رقم 6

THERMOSTAT CALIBRATION 1. Turn on unit. Set control dial at desired temperature. 2. Allow control to cycle at least three times (3) and observe temperature at the middle of the fourth cycle. 3. If calibration is required, carefully remove dial knob. Do not turn shaft. 4. Turn calibration screw in center of dial shaft clockwise to lower temperature and counter-clockwise to increase temperature. 5. Allow unit to cycle three (3) times and observe temperature at middle of fourth cycle.