Toshiba RBC-FDP2-F-PE دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

ON ON
Mounting Standard Operation
RBC-FDP2-F-PE Interface
SW1 SW7
75.00
FDP2 Configuration Switches
Installation and Operating Instructions The FDP2 should be
The FDP2 has a number of standard configurations that can be set using
mounted using the
switches SW1 to SW7 shown above. Factory configuration is configured
keyhole mounting
with all switches OFF. In this mode the FDP2 operates as a standard fault
points as indicated in
Ø 4.00
monitoring device. Additional preset modes are available using

ملخص المحتوى في الصفحة رقم 2

FDP2 Advanced Operation FDP2 Group Control FDP2 Duty/Standby Operation ADDRESSING Group control allows up to 16 FDP2s to be connected on a D-Bus local Duty/Standby will alternately run two systems on 24 hour SW3 ON for The FDP2 has the facility to create control groups using multiple FDP2s network. Each FDP2 reports faults for the locally attached units. The alternating run/standby. If a fault occurs on either system Duty/standby connected together on the D-Bus network. In standard configurati