ملخص المحتوى في الصفحة رقم 1
2000
Getting Started Guide
Revision Date: 02.28.2003
9032766-09
ملخص المحتوى في الصفحة رقم 2
ELECTRICAL HAZARD: Only qualified personnel should perform installation procedures. NOTICE Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made. The hardware, firmware, or software described in this document is subject to change without notice. IN NO EVENT SHALL ENTERASYS NETWOR
ملخص المحتوى في الصفحة رقم 3
FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against ha
ملخص المحتوى في الصفحة رقم 4
SAFETY INFORMATION CLASS 1 LASER TRANSCEIVERS THE SINGLE MODE INTERFACE MODULES USE CLASS 1 LASER TRANSCEIVERS. READ THE FOLLOWING SAFETY INFORMATION BEFORE INSTALLING OR OPERATING THESE MODULES. The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop eliminates the need for maintenance checks or adjustments. The output is factory set, and does not allow any user adjustment. Class 1 Laser transceivers comply with the following safety
ملخص المحتوى في الصفحة رقم 5
ENTERASYS NETWORKS, INC. PROGRAM LICENSE AGREEMENT BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT. This document is an agreement (“Agreement”) between the end user (“You”) and Enterasys Networks, Inc. on behalf of itself and its Affiliates (as hereinafter defined) (“Enterasys”) that sets forth Your rights and obligations with respect to the Enterasys software program (including any accompanying documentation, hardware or media) (“Program”) in the packag
ملخص المحتوى في الصفحة رقم 6
If the Program is exported from the United States pursuant to the License Exception CIV under the U.S. Export Administration Regulations, You agree that You are a civil end user of the Program and agree that You will use the Program for civil end uses only and not for military purposes. If the Program is exported from the United States pursuant to the License Exception TSR under the U.S. Export Administration Regulations, in addition to the restriction on transfer set forth in Sections 1 or
ملخص المحتوى في الصفحة رقم 7
10. ENFORCEMENT. You acknowledge and agree that any breach of Sections 2, 4, or 9 of this Agreement by You may cause Enterasys irreparable damage for which recovery of money damages would be inadequate, and that Enterasys may be entitled to seek timely injunctive relief to protect Enterasys’ rights under this Agreement in addition to any and all remedies available at law. 11. ASSIGNMENT. You may not assign, transfer or sublicense this Agreement or any of Your rights or obligations under thi
ملخص المحتوى في الصفحة رقم 8
DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC 73/23/EEC Manufacturer’s Name: Enterasys Networks, Inc. Manufacturer’s Address: 35 Industrial Way PO Box 5005 Rochester, NH 03866-5005 European Representative Address: Enterasys Networks Ltd. Nexus House, Newbury Business Park London Road, Newbury Berkshire RG14 2PZ, England Conformance to Directive(s)/Product Standards: EC Directive 89/336/EEC EC Directive 73/23/EEC EN 55022 EN 55024 EN 60950 EN 60825 Equipment Type/Envir
ملخص المحتوى في الصفحة رقم 9
Contents About this Guide ................................................................................................ xiii What’s New............................................................................................................................. xiii Who should Read this Guide?................................................................................................. xiii How to Use this Guide ...............................................................................
ملخص المحتوى في الصفحة رقم 10
Contents LEDs................................................................................................................... 15 1000BASE-LX Expansion Module ........................................................................... 16 Cabling and Connector Specifications ............................................................... 17 LEDs................................................................................................................... 17 Dual Serial and Quad Serial – C/C
ملخص المحتوى في الصفحة رقم 11
Contents Activating the Configuration Commands in the Scratchpad .............................................61 Saving the Active Configuration to the Startup Configuration File ..................................61 Viewing the Current Configuration ...................................................................................61 Appendix A: Troubleshooting ............................................................................63 Appendix B: Technical Support ...........................
ملخص المحتوى في الصفحة رقم 12
Contents xii Enterasys X-Pedition 2000 Getting Started Guide
ملخص المحتوى في الصفحة رقم 13
About this Guide This guide provides a general overview of the 2-slot Enterasys Networks XP-2000 hardware and software features and provides procedures for installing the XP-2000. For product information not available in this guide, see the manuals listed in Related Documentation on page xiv. What’s New The content of this manual includes the addition of new and extended capabilities for the following: Powering On and Booting the Firmware on page 43 Starting the Command Line Interface on page
ملخص المحتوى في الصفحة رقم 14
Preface If You Want To... See... Troubleshoot installation problems Appendix A, Troubleshooting Contact Enterasys Networks for technical support Appendix B, Technical Support Related Documentation The Enterasys Networks documentation set includes the following items. Refer to these other documents to learn more about your product. For Information About... See the... How to use Command Line Interface (CLI) commands Enterasys Networks User Reference to configure and manage the XP-2000 Manual The
ملخص المحتوى في الصفحة رقم 15
Preface A description of any action(s) already taken to resolve the problem (e.g., changing mode switches, rebooting the unit, etc.) The serial and revision numbers of all involved Enterasys Networks products in the network A description of your network environment (layout, cable type, etc.) Network load and frame size at the time of trouble (if known) Enterasys X-Pedition 2000 Getting Started Guide xv
ملخص المحتوى في الصفحة رقم 16
Preface xvi Enterasys X-Pedition 2000 Getting Started Guide
ملخص المحتوى في الصفحة رقم 17
Chapter 1 Features Overview The Enterasys Networks XP-2000 provides non-blocking, high-speed Layer-2 (switching), Layer-3 (routing), and Layer-4 (application) switching. This chapter provides a basic overview of the XP- 2000 software and hardware feature set. If you want to skip this information and install the XP-2000 now, see Chapter 2, Hardware Installation. If you want to boot the XP-2000 software and perform basic configuration tasks now, see Chapter 3, Firmware Installation and Set
ملخص المحتوى في الصفحة رقم 18
Specifications The following table lists the basic hardware and software specifications for the XP-2000. Table 1. Basic hardware and software specifications Feature Specification Throughput 8.0-Gbps non-blocking switching fabric 6.0 million packets-per-second routing throughput Capacity Up to 16,000 routes Up to 128,000 Layer-4 application flows Up to 180,000 Layer-2 MAC addresses 4,096 Virtual LANs (VLANs) 2,000 Layer-2 security and access-control filters 3MB input/output buffe
ملخص المحتوى في الصفحة رقم 19
Features that are not shaded. Notice that Layer-2 is divided into an LLC layer and a MAC layer. The XP- 2000 operates at the MAC layer but not the LLC layer. Layer 7 Application Layer 6 Presentation Layer 5 Session Layer 4 TCP/UDP - application Layer 3 IP/IPX - routing Layer 2 LLC Layer 2 MAC -bridging Layer 1 Physical Interfaces TCP/UDP Services The following table lists some well known TCP/UDP services provided by the XP-2000. Table 2. TCP/UDP services TCP Port UDP Port Description 23 Telnet
ملخص المحتوى في الصفحة رقم 20
Features Statistics Management Bridging The XP-2000 provides the following types of high-speed bridging: Address-based bridging – The XP-2000 performs this type of bridging by looking up the destination address in an L2 lookup table on the expansion module that receives the bridge packet from the network. The L2 lookup table indicates the exit port(s) for the bridged packet. If the packet is addressed to the XP-2000’s own MAC address, the packet is routed rather than bridged. Flow-b
