Crown Boiler 50-003 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Crown Boiler Company
CWD Series Boilers
50-003 (3”), 50-004 (4”)
Coaxial Terminal Installation Instructions
CAUTION
• This terminal is for use on Crown CWD Series boilers only. Do not use this terminal on any other appliance.
• See the CWD Series Installation Manual for complete vent system installation instructions.
NOTE
• Coaxial portion of inside terminal section may be installed in direct contact with combustible construction.
• Maximum wall thickness through which this terminal can be

ملخص المحتوى في الصفحة رقم 2

8. Loosen the hose clamp on the end of the exhaust terminal. Mount the exhaust terminal onto the intake terminal with the “V” horizontal (fl ue gas openings on top and bottom) as shown in Figure 1b. Slip the hose clamp over the “fi ngers” on the intake terminal and tighten the clamp. 9. Seal all exposed exterior joints, including the joint between the wall face plate and the wall and between the wall face plate and the straight section with an exterior grade silicone sealant. 10. Attach the in