ملخص المحتوى في الصفحة رقم 1
BiPAC 7404V(G)OX
BiPAC 7404V(G)PX
3G/VoIP/(802.11g) ADSL2+ (VPN)
Firewall Router
User Manual
Version release 5.53.s5.rc3
Last Revised Date 23-10-2008
ملخص المحتوى في الصفحة رقم 2
Table of Contents Chapter 1: Introduction .....................................................................1 Introduction to your Router ..................................................................1 Features ............................................................................................1 Chapter 2: Installing the Router .......................................................5 Important note for using this router ....................................................5 Packag
ملخص المحتوى في الصفحة رقم 3
Error Log ...........................................................................................30 Diagnostic .........................................................................................30 Quick Start ............................................................................................31 Configuration ........................................................................................35 LAN - Local Area Network ........................................................
ملخص المحتوى في الصفحة رقم 4
Firewall Log .....................................................................................85 VPN - Virtual Private Networks (Only available for BiPAC 7404V(G)OX) 86 PPTP (Point-to-Point Tunneling Protocol) ..............................................86 IPSec (IP Security Protocol) ................................................................95 L2TP (Layer Two Tunneling Protocol) .................................................104 VoIP - Voice over Internet Protocol ................
ملخص المحتوى في الصفحة رقم 5
Appendix: Product Support & Contact ........................................162
ملخص المحتوى في الصفحة رقم 6
Chapter 1: Introduction Introduction to your Router Welcome to the 3G/VoIP/ (802.11g) ADSL2+(VPN) Firewall Router. The router is an “all-in-one” ADSL router, combining an ADSL modem, ADSL router and Ethernet network switch functionalities, providing everything you need to get the machines on your network connected to the Internet over your ADSL broadband connection. With features such as an ADSL Quick-Start wizard and DHCP Server, you can be online in no time at all and with a minimum of fus
ملخص المحتوى في الصفحة رقم 7
Multi-Protocol to Establish a Connection It supports PPPoA (RFC 2364 - PPP over ATM Adaptation Layer 5), RFC 1483 encapsulation overATM (bridged or routed), PPP over Ethernet (RFC 2516), and IPoA (RFC1577) to establish a connection with the ISP. The product also supports VC-based and LLC-based multiplexing. Quick Installation Wizard It supports a WEB GUI page to install this device quickly. With this wizard, end users can enter the information easily which they get from their ISP, then surf t
ملخص المحتوى في الصفحة رقم 8
Quality of Service (QoS) QoS gives you full control over which types of outgoing data traffic should be given priority by the router, ensuring important data like gaming packets, customer information, or management information move through the router ay lightning speed, even under heavy load. The QoS features are configurable by source IP address, destination IP address, protocol, and port. You can throttle the speed at which different types of outgoing data pass through the router, to ensur
ملخص المحتوى في الصفحة رقم 9
Firmware Upgradeable Device can be upgraded to the latest firmware through the WEB based GUI. Rich Management Interfaces It supports flexible management interfaces with local console port, LAN port, and WAN port. Users can use terminal applications through the console port to configure and manage the device, or Telnet, WEB GUI, and SNMP through LAN or WAN ports to configure and manage the device. Virtual Private Network (VPN) (BiPAC 7404V(G)OX only) It allows user to make a tunnel with a rem
ملخص المحتوى في الصفحة رقم 10
Chapter 2: Installing the Router Important note for using this router Package Contents 3G/VoIP/(802.11g) ADSL2+ (VPN) Firewall Router CD-ROM containing the online manual RJ-11 ADSL/telephone Cable Ethernet (CAT-5) Cable Console kit Power adapter A detachable antenna Quick Start Guide 5
ملخص المحتوى في الصفحة رقم 11
The Front LEDs. LED Meaning Lit when power is ON. Lit red means system failure. Restart the device 1 Power or contact Billion for support. Lit when one of LAN ports is connected to an Ethernet device. Ethernet Port Lit green when the speed of transmission hits 100Mbps; Lit orange 2 1X — 4X when the speed of transmission hits 10Mbps. (RJ-45 connector) Blink when data is being Transmitted / Received. Lit when the router is connected to a USB device. 3 USB Flash when data is received / tr
ملخص المحتوى في الصفحة رقم 12
The Rear Ports Port Meaning Antenna 1 Connect the detachable antenna to this port. (Wireless Router only) Connect this port to the ADSL/telephone network with the RJ- 2 DSL 11 cable (telephone) provided. Line Connect this port to the telephone jack on the wall with RJ-11 3 cable. (Router with LINE port only) Phone 4 Connect this port to an analog phone set with RJ-11 cable. 1X-2X (RJ-11 connector) 5 USB Connect the USB cable to this port. Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one
ملخص المحتوى في الصفحة رقم 13
Cabling One of the most common causes of problem is bad cabling or ADSL line(s). Make sure that all connected devices are turned on. On the front panel of your router is a bank of LEDs. Verify that the LAN Link and ADSL line LEDs are lit. If they are not, verify if you are using the proper cables. Make sure that all devices (e.g. telephones, fax machines, analogue modems) connected to the same telephone line as your router have a line filter connected between them and the wall outlet (unless
ملخص المحتوى في الصفحة رقم 14
Chapter 3: Basic Installation The router can be configured through your web browser. A web browser is included as a standard application in the following operating systems: Linux, Mac OS, Windows 98/NT/2000/XP/Me/Vista, etc. The product provides an easy and user-friendly interface for configuration. Please check your PC network components. The TCP/IP protocol stack and Ethernet network adapter must be installed. If not, please refer to your Windows-related or other operating system manuals.
ملخص المحتوى في الصفحة رقم 15
Connecting Your Router 1. Connect this router to a LAN (Local Area Network) and the ADSL/telephone (ADSL) net work. 2. Power on the device. 3. Make sure the Power LED lit steadily and that the LAN LED is lit. 4. Connect your router to the telephone jack on the wall with RJ-11 cable. 5. Connect the USB 2.0 cable. 10
ملخص المحتوى في الصفحة رقم 16
Network Configuration Configuring PC in Windows Vista 1. Go to Start. Click on Network. 2. Then click on Network and Sharing Center at the top bar. 3. When the Network and Sharing Center window pops up, select and click on Manage network connec- tions on the left window column. 4. Select the Local Area Connection, and right click the icon to select Properties. 11
ملخص المحتوى في الصفحة رقم 17
5. Select Internet Protocol Version 4 (TCP/IPv4) then click Properties. 6. In the TCP/IPv4 properties window, select the Obtain an IP address au- tomatically and Obtain DNS Server address automatically radio but- tons. Then click OK to exit the set- ting. 7. Click OK again in the Local Area Connection Properties window to apply the new configuration. 12
ملخص المحتوى في الصفحة رقم 18
Configuring PC in Windows XP 1. Go to Start > Control Panel (in Classic View). In the Control Panel, double-click on Network Connections 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window, click Properties. 4. Select Internet Protocol (TCP/IP) and click Properties. 5. Select the Obtain an IP address auto- matically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration. 13
ملخص المحتوى في الصفحة رقم 19
Configuring PC in Windows 2000 1. Go to Start > Settings > Control Panel. In the Control Panel, double-click on Network and Dial-up Connections. 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window click Properties. 4. Select Internet Protocol (TCP/IP) and click Properties. 5. Select the Obtain an IP address auto- matically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration. 14
ملخص المحتوى في الصفحة رقم 20
Configuring PC in Windows 95/98/Me 1. Go to Start > Settings > Control Panel. In the Control Panel, double-click on Network and choose the Configuration tab. 2. Select TCP/IP > NE2000 Compatible, or the name of your Network Interface Card (NIC) in your PC. 3. Select the Obtain an IP address auto- matically radio button. 4. Then select the DNS Configurationtab. 5. Select the Disable DNS radio button and click OK to finish the configuration. 15
