AMX NetLinx Touch Panel Interface 4 NXP-TPI/4 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Quick Start Guide
NXP-TPI/4 NetLinx Touch Panel Interface 4
For more detailed installation, configuration, programming, and operating
Removing the Input Card Covers
instructions, refer to the NXP-TPI/4 Touch Panel Interface Instruction Manual
1. Discharge the static electricity from your body by touching a grounded
available on-line at www.amx.com.
metal object and disconnect all connectors from the NXP-TPI/4.
2. Carefully unscrew (counter-clockwise) the two flat phillips-head (top of
each

ملخص المحتوى في الصفحة رقم 2

6. Connect an Ethernet cable to the rear of the TPI/4. This cable provides 10/100 network connectivity between the unit and the NetLinx Master. 7. Cycle power to the unit. This cycling allows the unit to detect the new configuration. Note: Verify that all rear connectors are connected prior to the unit being installed onto a surface or within an equipment rack. Once the TPI/4 has been Select NullTouch when configured, connected, and installed properly; you can then provide power. using th