Transition Networks SPS-1872-PS دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

SPS-1872-CC (Conversion Center™)
User’s Guide
SPS-1872-DPS (Dual PointSystem™)
SPS-1872-xx
SPS-1872-PS (PointSystem™)
External Power Supply
SPS-1872-SA (Stand-Alone)
18-60 VDC and 24-30 VRMS
SPS-1872-SA
SPS-1872-CC
SPS-1872-DPS
SPS-1872-PS
The Transition Networks SPS-1872-xx external power supply provides a wide range
of input power (18-60 VDC and 24-30 VRMS) to accommodate most industrial,
telecom, and commercial applications. The SPS-1872-xx can deliver 12 watts of
power, enough to power all

ملخص المحتوى في الصفحة رقم 2

SPS-1872-xx Installation and Service Installation -- Continued All Installation and service must be performed by qualified service personnel. SPS-1872-SA (Stand Alone) Read and follow all warning notices and instructions marked on the product or NOTE: The SPS-1872-SA external power supply is shipped with four (4) included in the manual. attached feet. 1. Place on any well-ventilated table-top or shelf with access to a power Required Grounding source with a range between 18-60 VDC or 24-30 VRMS.

ملخص المحتوى في الصفحة رقم 3

SPS1872-xx Installation -- Continued Installation -- Continued SPS-1872-CC (Conversion Center™) SPS-1872-DPS (Dual PointSystem™) 1. Remove the left-rear and right-rear screws from the Conversion Center™ 1. Remove the left-rear and right-rear screws from the Dual PointSystem™ media converter. media converter. 2. Connect the barrel connector on the SPS-1872-CC to the power port of 2. Connect the barrel connector on the SPS-1872-DPS to the power port of the media converter The flange of the SPS-1

ملخص المحتوى في الصفحة رقم 4

SPS-1872-xx Installation -- Continued Maintenance Supplying Power to the SPS-1872-xx Replacing the Fuse CAUTION: The power source MUST BE TURNED OFF when connecting it to CAUTION: The external power source MUST BE POWERED OFF when the SPS-1872-xx external power supply. Failure to observe this caution could replacing the fuse to the SPS-1872-xx external power supply. Failure to observe result in damage to, and subsequent failure of, the SPS-1872-xx and any attached this caution could result

ملخص المحتوى في الصفحة رقم 5

SPS1872-xx Technical Specifications Technical Specifications -- Continued For use with Transition Networks Model SPS-1872-xx or equivalent. Input: Product is certified by the manufacturer to comply with DHHS Rule 21/CFR, Input Voltage 18 - 60 VDC, 24 - 30 VRMS Subchapter J applicable at the date of manufacture. Isolation Voltage (Dielectric withstand) Meets IEC 950 for one minute Compliance UL listed EN60950; FCC & CISPR class A; CE Mark 1500 VAC: Output/Input 1500 VAC: Input/Safety GND Dimens

ملخص المحتوى في الصفحة رقم 6

SPS-1872-xx Contact Us Compliance Information Technical Support UL Listed Technical support is available 24 hours a day. C-UL Listed (Canada) United States: 1-800-260-1312 CISPR/EN55022 Class A + EN55024 International: 00-1-952-941-7600 FCC Regulations This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable Transition Now protection against harmful interference when th

ملخص المحتوى في الصفحة رقم 7

Trademark Notice All trademarks and registered trademarks are the property of their respective owners. Copyright Restrictions © 2003, 2005 Transition Networks. All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from Transition Networks. Printed in the U.S.A. 33266.E