Attwood Tsunami 4613 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Figure 1
®
Thru-Hull Connector
Hose & Clamp
3
12" min. Above
Base Strainer
Tsunami Bilge Pump
Water Line
4606, 4608, 4612, 4613 Series
Installation Instructions
SAVE THESE INSTRUCTIONS
Hose MUST Rise
Form Number 69390 Rev. A 10-03
Upward with NO DIP
Suitable Mounting Pad
WARNING
2. Do not mount pump directly to hull. Attach base strainer to a
Read all instructions carefully before installing and using this product.
marine plywood mounting pad that is fiberglassed to the hull.
To prevent person

ملخص المحتوى في الصفحة رقم 2

Figure 3 MAINTENANCE AND TROUBLESHOOTING Disconnect power to the pump. Regularly inspect and clean to be Fuse Holder 72" (183cm) Max. Length sure that debris is not blocking the strainer or impeller. From (+) Terminal to Fuse If pump runs but does not pump water: 1. Check for airlock. Be sure that outlet hose runs upward to the 2-Terminal thru-hull connector, with no dips. (Figure 1) On/Off Switch 2. Remove pump housing from base. Remove debris from chamber and impeller. Be sure impeller is firm