Paradyne IP Broadband Loop Carrier 4000 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

IP DSL Access
Multiplexer

Hardware Installation
Guide
• IPD12000
• IPD4000















© Copyright 1998-2001 Net to Net Technologies, Inc.

™ “DSL The Easy Way” and the Net to Net Logo are trademarks of Net to Net Technologies, Inc.

This manual may not be duplicated without prior permission from Net to Net Technologies, Inc.

This document is intended as a usage guide for the IP DSLAM family of products. All features defined herein are subject to change. A

ملخص المحتوى في الصفحة رقم 2

Table of Contents Table of Contents.............................................................................................................................................................. 2 IP DSL Access Multiplexer Overview................................................................................................................................3 IP DSL Access Multiplexer 12000 .....................................................................................................

ملخص المحتوى في الصفحة رقم 3

IP DSL Access Multiplexer Overview Net to Net Technologies’ IP DSLAMs are designed to deliver high-speed data and voice connections over existing telephone copper lines. The IPD12000 and IPD4000 multiplex multiple access technologies (IDSL, SDSL, T1, ADSL, etc.) for upstream delivery to the provider’s packet network. The IP DSLAMs achieve this in conjunction with Net to Net Subscriber Units, which are used on the other end of the copper line at the customer premise. This purpose of thi

ملخص المحتوى في الصفحة رقم 4

Installation Net to Net Technologies strongly recommends using proper grounding techniques when installing the IP DSLAM chassis and modules. DC Power Installations 1. When mounting unit into an equipment rack please adhere to the following: • Maximum recommended ambient temperature is 30°C. Internal temperatures of rack should be considered for continued safe operation. • Do not block power supply vents or otherwise restrict airflow when installing unit in rack. • Mechanical loa

ملخص المحتوى في الصفحة رقم 5

AC Power Installations An external power converter is required to power the IP DSLAMs. Follow the instructions included with the AC to DC power converter you are using to power the IP DSLAM. - + G Installing Access and Uplink Modules 1. Ensure that proper grounding techniques are being used when installing modules into the IP DSLAM. 2. Align module with slot module guides and slide module gently but firmly all the way into the chassis. 3. Tighten scre

ملخص المحتوى في الصفحة رقم 6

Connecting Cables to the IP DSLAMs Cables used to connect copper pairs into the IP DSLAMs may be connected with the chassis powered on or off. Extra caution should be taken when installing cables near the DC terminal blocks. Cable pin-out information is module specific; refer to the User Manual for each module for cable pin-out information. To install cables on the back of the IP DSLAMs, simply push the RJ-21 connector on to the connector on the back of the chassis. Secure the cabl