Omnitron Systems Technology iConverter Gx AN دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

from the power cable wires. Connect the power cables to the unit by fastening the
stripped ends to the DC power connector.
Connect the power wires to the DC power source. The Power LED should indicate
the presence of power.
iConverter Gx AN Standalone Module QUICK START GUIDE
WARNING: Note the wire colors used in making the positive and negative
®
The Omnitron iConverter Gx AN Standalone media converter provides 1000BASE-T
connections. Use the same color assignment for the connection at the DC

ملخص المحتوى في الصفحة رقم 2

Switch Down Up SW6, SW7, SW8 - Link Modes (Factory Default) These three DIP-switches configure the link mode settings. DIP-switch SW6 is valid SW1 P1 AN: P1 MAN: Port 1 Port 1 when Port 1 is set to “AN” or “MAN”. DIP-switches SW7 and SW8 are ignored when Fiber Auto-Negotiation Fiber Manual Negotiation Port 1 is set to “AN”. The following table details possible Link Mode DIP-switch SW2 P2 AN: P2 MAN: Port 2 Port 2 configurations. UTP Auto-Negotiation UTP Manual SW3 FDX: HDX: SW1 SW6 SW7 SW8