Klaxon Flashguard LED Flasher Module 102325 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation Instructions
Flashguard LED Flasher Module
To Flashguard Xtra
1. Straighten the two LEDs by gently bending them in to
the upright position.
2. Peel the backing off the adhesive mounting brackets
provided and attach them to the inside of the cover as
shown below.
6 cm
3. Connect the unit to a suitable 12V supply, observing
polarity. The two LEDs will now flash alternately.
4. Slot the PCB into the mounting brackets with the LEDs
pointing towards the lens. Bend the LEDs into posi

ملخص المحتوى في الصفحة رقم 2

Installation Instructions Flashguard LED Flasher Module To Flashguard XL PLus 1. Straighten the two LEDs by gently bending them in to the the upright position. 2. Fix the board to the cut-out inside the cover using the self-ashesive pads provided. Screws can be used if desired. 3. Connect the unit to a suitable 12V supply, observing polarity. The two LEDs will now flash alternately. 4. Fix the unit to the wall in the same way as an ordinary simulated unit. PCB Part No. 102325 The In