ملخص المحتوى في الصفحة رقم 1
TLP 700MV Setup Guide
Overview
® ™
The Extron TLP 700MV is a wall-mounted TouchLink Panel that
provides simple and versatile configuration and control for a range
®
of IP Link control systems.
Graphic and text objects are displayed on the screen. These objects
have system control functions associated with them and the touch
overlay allows you to activate or regulate those functions.
The TLP 700MV communicates with the configurable IP Link controller through an Ethernet connection to an IP Li
ملخص المحتوى في الصفحة رقم 2
TLP 700MV Setup Guide (Continued) Mounting the TLP 700MV The TLP 700MV can be mounted in a standard 19 inch equipment rack, using the optional Extron RM 700M rack mounting kit (part #70-683-01). See the kit for full installation instructions. For wall-mounting, Extron recommends using the TR 700M trim ring to cover any ragged edges to the hole cut in step 3 below. This optional part can be used with other TouchLink panel accessories (see www.extron.com for details). To mount the TLP 700MV in t
ملخص المحتوى في الصفحة رقم 3
Configuring the TLP 700MV (Initial Setup) Before using the TLP 700MV, it is essential to configure it using the on-screen menus. There are five different screens (Main, Volume, Time, Network, and Video) that can be selected by pressing the appropriate button at the left side of the screen. There is also an Exit button at the bottom left corner of the screen for leaving the menus. Setup Menu 1. Press the recessed Menu button to activate the top-level menu screen. The menu opens at the Main Set
ملخص المحتوى في الصفحة رقم 4
TLP 700MV Setup Guide (Continued) Designing the TLP 700MV Interface with GUI Configurator Install the GUI Configurator software on a PC and use it to design the interface that will appear on the TLP 700MV screen. NOTE: The Extron GUI Configurator software is on the disk that comes with the TouchLink Panel and may also be downloaded (free of charge) from the Extron Web site (www.extron.com). For information about downloading GUI Configurator, consult the user guide. Open the program by c
