ملخص المحتوى في الصفحة رقم 1
570
Pumped Electric Shower
Installation instructions & User guide
IMPORTANT: This booklet should be given to the customer after installation and demonstration.
WARNING: Under no circumstances should this unit be connected to the mains cold water supply.
ملخص المحتوى في الصفحة رقم 2
Diagram 1 Thank you for choosing a quality 'Redring' Knob 'A' product manufactured in Peterborough, England. CONTENTS Page Overheat Light Information for the user Important Safety Instructions 2 How to use your 'Redring' shower 2 How your 'Redring' shower works 3 Power On Light How to maintain your 'Redring' shower 4 What to do if things go wrong 4 Additional accessories 9 Information for the installer Fixing the shower to the wall 6 Knob 'B' Plumbing 7 Electrical 8 Guarantee 12 HOW TO USE YOUR
ملخص المحتوى في الصفحة رقم 3
the option of reduced water flow. This option knob 'B' anti-clockwise to a lower number on is mainly for summer usage and if this is used the temperature scale. then knob 'B' must be re-adjusted. WARNING! DO NOT SWITCH THE 8. When you have finished showering turn knob SHOWER ON IF YOU SUSPECT IT OF 'B' fully clockwise to the '• Stop' position. BEING FROZEN. WAIT UNTIL YOU ARE The motor will switch off and water will stop SURE IT HAS THAWED OUT. flowing. The 'POWER ON' light will also HOW YOUR 'R
ملخص المحتوى في الصفحة رقم 4
temperature climbs above a set limit and the HOW TO MAINTAIN YOUR 'overheat' light will come on. This cut-out 'REDRING' SHOWER which gives an audible click, may also All water contains particles of lime which build up operate due to residual heat when the shower in the showerhead and unit reducing the is switched off. It will reset itself if cold water performance. It is therefore important to clean the is run through the shower for 10 to 20 showerhead by regularly dipping it in a suitable secon
ملخص المحتوى في الصفحة رقم 5
Professional Service b)Water too Check power is on (indicated If the previous checks fail to restore the COLD by 'power on' light). Decrease water flow by performance, you should seek professional help. adjusting the temperature The person who installed the shower is probably control (knob 'B') clockwise to the best one to repair it and is certainly the a higher number on the person to contact if you have a problem in the temperature scale. guarantee period. Switch power to ' high • The followi
ملخص المحتوى في الصفحة رقم 6
A) Fixing the shower to the wall e) Water leaks Check for cause of high from burst pressure and remove it. The Redring Expressions 570 Pumped Blockage on outlet i.e: blocked Electric Shower is fitted with a motor and pressure some mechanical noise can be expected spray plate etc. Replace the relied valve when in use. The type of wall structure will pressure relief disc. affect the noise levels. Solid walls will provide quieter operation than panel or stud REDRING AFTER SALES SERVICE partition wa
ملخص المحتوى في الصفحة رقم 7
b) The heater must not be mounted in the It is strongly advised to install the shower unit direct spray from the handset. using an independent supply from the cold water storage cistern. The shower would then be totally c) The handset must not be able to come into unaffected by other draw off points elsewhere in contact with the used water in the cubicle, the system and thus the pressure and bath or basin. If it can, even after the hose temperature will remain more stable. Therefore has been ret
ملخص المحتوى في الصفحة رقم 8
6. The shower is designed to have an open 2. Cable Sizes outlet and should only be used with Redring Model Cable Sizes Fuse Type recommended fittings. 2 Exp. 570 6mm 40 A Cartridge Fuse WARNING: DO NOT FIT A TAP ON THE (8.5 kW) Type 'A' MCB SHOWER OUTLET. TAKE CARE TO AVOID 2 10mm 45 A Cartridge Fuse RESTRICTING THE OUTLET OF THE 2 Exp. 570 (9.5 kW) 10mm 45 A Cartridge Fuse PRESSURE RELIEF DEVICE. (SHOWN IN DIAGRAM 2). Expressions 570 9.5/8.7kW, 240/230V, version 2 may be able to use 6mm cable i
ملخص المحتوى في الصفحة رقم 9
5. A dual position cable clamp is provided. For c) Power selection operates in both positions, top cable entry use retaining bar in horizontal giving a change in water temperature position supplied. For bottom cable entry d) Check again for leaks rotate retaining bar to the angled position. e) That the holes in the spray plate are not 6. WARNING: THIS APPLIANCE MUST BE blocked EARTHED. f) That the motor turns off and water stops 7. The earth flowing in the 'STOP' position 8mm 10mm continuity 5mm
ملخص المحتوى في الصفحة رقم 10
ASSEMBLY OF RISER RAIL, HANDSET AND SOAP DISH Diagram 12 Additional knock out fixing slot if required Removable insert in soap Locating dish for ease Key of cleaning 10
ملخص المحتوى في الصفحة رقم 11
ملخص المحتوى في الصفحة رقم 12
Guarantee We, Applied Energy Products Limited, guarantee that should this instant water heater prove to be defective by reason of faulty workmanship or material within 24 months (outside of U.K. please contact your local distributor) of the date of purchase or commencement of hire purchase we will replace the defective parts FREE OF CHARGE on condition that: The appliance has been correctly installed and used only on the supply • circuit or voltage stamped on the rating plate. The appliance has
