ملخص المحتوى في الصفحة رقم 1
2
SeaTalk Keyboard
www.raymarine.com
Owner's Handbook
Introduction
PAGE
WPTS
ACTIVE
MOB
DATA
MENU
OK CANCEL
.
2
This handbook explains how to install, connect, operate and maintain your SeaTalk
Keyboard (E55061). This keyboard is also supplied with the Remote Station Kit (T82005) -
details of how to integrate these devices is given on Page 6.
Intended use
This keyboard is intended for use with Raymarine's E-Series display aboard leisure marine
boats and workboats not covered by
ملخص المحتوى في الصفحة رقم 2
The controls WPTS Power MOB To turn display off and access To manage waypoints and backlight functions and initiate MOB. scanner controls. PAGE Soft keys Trackpad To change page and Press to select corresponding function To control on-screen configure page sets. identified by on-screen label. cursor and scroll through menu items. PAGE 1 2 3 WPTS ACTIVE MOB ABC DEF DATA MENU 4 5 6 GHI JKL MNO 7 8 9 OK CANCEL PQRS TUV WXYZ 0 . ACTIVE MENU Keypad Range CANCEL To select the To acces
ملخص المحتوى في الصفحة رقم 3
Whats in the box?. . . . Suncover Stud (x2) Clamp (x2) Thumb nut (x2) 2 SeaTalk Keyboard Drain tube (8mm x 1m) 2 SeaTalk cable (1.5m) 2 Cradle SeaTalk power/RF ground cable (1.5m) 2 SeaTalk Keyboard Terminator (x2) Owner's Handbook www.raymarine.com 2 Introduction to the SeaTalk Keyboard PAGE ACTIVE WPTS Gasket MOB DATA MENU OK CANCEL . This handbook explains how to install, connect, operate and maintain your SeaTalk2 Keyboard (E55061). This keyboard is also supplied with the Remo
ملخص المحتوى في الصفحة رقم 4
Planning the installation 2 Where can the SeaTalk Keyboard be mounted? 2 The Seatalk keyboard can be flush or trunnion mounted either indoors or outdoors. It is waterproof to CFR-46 standard. Important: The drain tube is not required if the keyboard is mounted indoors or in an area protected from rain and/or sea spray. If mounting the keyboard outdoors or in an unprotected area the drain tube will need to run to a suitable exit point below the level of the keyboard. What conf
ملخص المحتوى في الصفحة رقم 5
Configuration 2 Cable length between E-Series Display and keyboard exceeds 4.5m and 2 Not linking into an existing SeaTalk system. E Series display Supplied in the box Not supplied/accessory/ existing system 2 SeaTalk Keyboard E-Series Display 2 2 SeaTalk extension cable SeaTalk cable (1.5m) (see 'Accessories') 2 SeaTalk Power/RF ground cable (1.5m) 5A circuit breaker Terminator Or: grey Terminator Switch with 5A fuse red black Additional junction box Junction box 12v supply Conf
ملخص المحتوى في الصفحة رقم 6
Integrating the Remote Station Kit Station 1 M1500 monitor Other SeaTalk No other SeaTalk devices connected devices connected Alarm Alarm 2 SeaTalk Keyboard 12v supply Drain OR Drain Other SeaTalk Yellow devices OR E Series Station 2 Refer to 'Planning the Installation', 2 diagrams on SeaTalk cable (1.5 m) pages 4 and 5. Junction box Keyboard cable (attached/3 m) Remote Station Kit Not supplied/accessory/existing system 6 Red Black Brown Red Yellow White Black SeaTalk/Alarm out ca
ملخص المحتوى في الصفحة رقم 7
Installation Note: Before installing the keyboard, please read 'Planning the installation' on Pages 4 & 5. What tools do I need to install the keyboard? Jigsaw Drill 3 Masking or 10 mm ( / in) File 8 adhesive tape drill bit How do I install the keyboard? 1. Using self-adhesive or masking tape, fix the 3. Saw around the shaded area of the template. template in the required position. Note: Ensure that there are no cables or other parts that will be damaged, when the panel is
ملخص المحتوى في الصفحة رقم 8
Installation - continued 5. Peel the backing from the gasket and stick it 8. Fit the keyboard assembly into its housing. to the underside of the cradle. With the dimples in the clamps fitting into the nipples on the cradle, fit and secure the clamps in place using the thumb nuts. 6. Finger tighten the studs into position. 9. Ensuring that the power is connected last, connect all the cables, terminators etc in the appropriate configuration (see 'Planning the Ins
ملخص المحتوى في الصفحة رقم 9
Accessories and spares What accessories are available? ... Description Part no. 2 SeaTalk power/RF ground cable (1.5m) E55070 Auxiliary alarm E26033 M1500 monitor kit (includes 5m VGA Out cable) E02009 Terminator E25048 Junction box E25049 2 SeaTalk extension cables: 1 metre E25040 3 metres E25042 5 metres E25043 10 metres E25038 20 metres E25044 2 E-Series SeaTalk cable (1.5m) E55053 VGA Out cables (waterproof): 10 metres E55055 20 metres E55056 Trunnion mount kit E05012 What spare
ملخص المحتوى في الصفحة رقم 10
Removing/refitting How do I remove the keyboard? ... 3. Push down at the top of the keyboard to 1. Switch off the power. raise it from the cradle and lift the it from the cradle. 2. Slide and hold the latch. How do I refit the keyboard? ... 2. Push the bottom of the keyboard into 1. Position the top edge of the keyboard the cradle to engage the latch. under the lip of the cradle. Maintenance What routine checks and servicing can I do? ... On a regular basis, examine all c
ملخص المحتوى في الصفحة رقم 11
Important information EMC conformance All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. The design and manufacture of Raymarine equipment and accessories conforms to the appropriate Electromagnetic Compatibility (EMC) standards, but correct installation is required to ensure that performance is not compromised. For full details and installation guidelines refer to our web site at www.raymarine.com
ملخص المحتوى في الصفحة رقم 12
Technical support & contact information www.raymarine.com Visit the Customer Support area of our website for Frequently Asked Questions, servicing information, e-mail access to the Raymarine Technical Support Department and details of Raymarine agents, worldwide. United States Europe For accessories and parts contact: For technical support, service and accessories contact: Your authorized Raymarine dealer. or Your authorized Raymarine dealer. Raymarine Technical Services on:
ملخص المحتوى في الصفحة رقم 13
2 2 SeaTalk Keyboard Interim sheet 82201-1 SeaTalk Keyboard Interim sheet 82201-1 Configuration 4 Configuration 4 Cable length between E-Series Display and keyboard less than 4.5m and Cable length between E-Series Display and keyboard less than 4.5m and 2 2 Linking into an existing combined SeaTalk/SeaTalk system with ST290 DPU. Linking into an existing combined SeaTalk/SeaTalk system with ST290 DPU. 2 2 Do not connect the ST290 to the E-Series SeaTalk connection. Do not connect the ST290 t
