Honeywell NPB-MDM دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

NPB-MDM Modem Card
INSTALLATION INSTRUCTIONS
SAFETY INSTRUCTIONS
GENERAL
• Keep these Installation Instructions for industrial safety
and the prevention of accidents.
• Only qualified personnel shall do mounting and
installation work with these devices, see section titled
CAUTION
“Qualified Personnel”.
This modem may require testing and
• The information in these instructions must be read and
certification in some European and Asian
understood by every person using this device.
countries p

ملخص المحتوى في الصفحة رقم 2

NPB-MDM MODEM CARD MOUNTING 4. Remove the Slot 1 blanking end plate. a. Retain the blanking end plate in case the WARNING NPB-MDM Modem Card must be removed at a Power to the WEB-201 Controller must be OFF later date. when installing or removing option cards, or 5. Carefully insert the pins of the NPB-MDM Modem damage will occur! Also, be very careful to Card into the socket of slot 1 option connectors. plug any option card into its connector The mounting holes on the option board should

ملخص المحتوى في الصفحة رقم 3

NPB-MDM MODEM CARD WIRING SERIAL SHELL NOTES Connect a standard RJ-11 telephone cable to the If an NPB-MDM Modem Card is installed and the WEB- connector on the NPB-MDM Modem Card and the other 201 Controller’s “Mode Jumper” (Refer to Fig. 4) is put in end to the working PSTN (dialup) telephone receptacle. “Serial Shell” position, the WEB-201 base RS-232 port becomes active immediately following a reboot. This allows an RS-232 connection to the “Serial Shell” for debugging purposes. The NPB-

ملخص المحتوى في الصفحة رقم 4

NPB-MDM MODEM CARD Automation and Control Solutions Honeywell International Inc. Honeywell Limited-Honeywell Limitée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Scarborough, Ontario M1V 4Z9 customer.honeywell.com ® U.S. Registered Trademark © 2006 Honeywell International Inc. 95-7730 J.I. 04-06